LUBRICATION

ORDER LO 5-4210-217-12
LI-00664G-12 15 MAY 1975 (Supersedes L05-4210-217-12 dated 6 APRIL 1973)

TRUCK, FIRE FIGHTING: POWERED PUMPER; FOAM AND WATER 750

G.P.M. CAP.; CENTRIFUGAL PUMP, POWER TAKE OFF DRIVEN; 400
GAL. WATER TANK, 40 GAL. FOAM CHEMICAL TANK, (ENGINEERED
DEVICES INC. MODEL 0814) FSN 4210-150-1426, (AMERICAN AIR
FILTER MODEL FT 750) FSN 4210-106-7432 AND WINTERIZED
(AMERICAN AIR FILTER MODEL FT 750W)
FSN 4210-106-7433
Reference: TM5-4210-217-12, LO9-2320-209-12, and FEDERAL SUPPLY CATALOG C9100-IL

Intervals are based on normal hours of operation. Adjust Dry before lubricating.
to compensate for abnormal operations and severe
conditions. Lubricate points indicated by dotted arrow shafts on both
sides of equipment.
During inactive periods sufficient lubrication must be
performed for adequate preservation. * The times specified are the hours required to perform
311 services at the particular interval.
Clean fittings before lubricating.
A dotted circle indicates a drain below.
Clean parts with SOLVENT, dry-cleaning, Type II (SD-2).

*TOTAL MAN-HR * TOTAL MAN-HR

INTERVAL MAN-HR INTERVAL MAN-HR
50 1.0 250 1.1
100 1.5 500 1.1

LUBRICANT INTERVAL INTERVAL LUBRICANT

Radiator Shutter OE/HDO
(See note 16) OE/HDO Tank, Priming Pump,
Check and Fill
(Fill to 1/2 inch from
top of tank)
(See note 7)
Bearing Outboard GAA
(See note 5) GAA Transfer Valve
(See note 8)
Pinion Shaft Bearing GAA GAA Transmission Interlock
(2 fittings) Cable
(2 fittings) (See note 4)
PTO Propeller Shaft GAA
Universal and Slip OE/HDO Electric Shift Unit
Joints (Check and fill)
(3 fittings) (See note 4 & 9)
(See note 4 & 6)
Fire Pump Gear Case GO Fire Pump Gear Case
(Check sight glass) (Fill and drain)
(See note 15) (Drain below)
Motor, Priming Pump OE/HDO
(See note 4 & 11)
 KEY

NOTES:
10. HOSE REEL. The motor, drum shaft bearings, and
1. FOR OPERATION OF EQUIPMENT IN swivel connection, do not require lubrication.
PROTRACTED COLD TEMPERATURES BELOW Lubricate hose reel drive chain with cloth saturated
10°F. (-23°C). Remove lubricants prescribed in the with OE/HDO.
key for temperatures above 10°F.(-23°C).
Relubricate with lubricants specified in the key for 11. PRIMING PUMP MOTOR. Every 500 hours or
temperatures below -10°F. (-23°C). semiannually, whichever occurs first, lubricate the
priming pump motor. The oil can point is located on
2. OIL CAN POINTS. Every 250 hours or quarterly, top of motor shaft housing. Use only a few drops of
whichever occurs first, clean and lightly coat door oil, do not over lubricate.
hinges and locks, push-pull operating control rods,
throttle control, '"latches, springs, and pinion gear, 12. FIRE PUMP. Every 500 hours or semiannually,
and all exposed threads 'with OE/HDO. whichever occurs first, lubricate the 5 gear sector
racks with GAA. The racks are installed on the 3
3. LUBRICANTS. The following is a list of lubricants discharge and 2 suction valves.
with Military Symbols and applicable Specification
numbers. 13. BATTERY COMPARTMENT. Every 500 hours or
semiannually, whichever occurs first, lubricate the
GO MIL-L-2105 GOS sliding trays, channels of top cover, and battery
MIL-L-10324 terminals with GAA.
OE/HDO MIL-L-2104C OEA
MIL-L-46167 14. FIRE PUMP PACKING GLANDS. The stuffing boxes
GAA MIL-G-10924 (2 each) are designed to leak slightly during
operation to cool and lubricate the packing.
Acceptable leakage rates are 10 drops minimum to
4. PUMP COMPARTMENT PANEL. Remove bottom 60 drops maximum of water per minute at 150 psig
cover panel of pump compartment for access to PTO discharge pressure. To adjust packing glands, refer
propeller shaft universal and slip joints, transmission to TM 5-4210-217-12.
interlock cable, electric shift unit, priming pump
motor, and draining fire pump gear case. 15. PUMP GEAR CASE. Check oil level after each use.
Add if required. Note: Area of check located under
5. BEARING OUTBOARD (IMPELLER SHAFT). Every left operator's panel on chassis member.
250 hours of operation or quarterly, whichever occurs
first, lubricate until lubricant appears at relief fitting. 16. RADIATOR SHUTTER. Position control assembly
The relief fitting is located directly below the screw to full exposure and apply OE/HDO to surface.
lubrication fitting.
Copy of this Lubrication Order will remain with the
6. PTO PROPELLER SHAFT UNIVERSAL JOINTS. equipment at all times; instructions contained herein are
To prevent damage to journal seals, use relief fitting mandatory.
with grease gun.
By Order of the Secretaries of the Army and the Navy:
7. TANK, PRIMING PUMP. Check and fill the tank
every fifty hours or after each use, whichever occurs FRED C. WEYAND
first. When changing from one grade of oil to General, United States Army
another, remove the tank and empty through fill Official: Chief of Staff
opening.
VERNE L. BOWERS
8. TRANSFER VALVE.. During lubrication, operate Major General, United States Army
transfer valve control several times to distribute the The Adjutant General
grease. E.J. MILLER
Major General, U. S. Marine
9. ELECTRIC SHIFT UNIT. Routine oil changes are Corps Deputy Chief of Staff
not necessary. Changing the lubricant is required for Installations & Logistics
only for cold weather operation or when shift unit is
removed. To drain the shift unit remove cover plate. DISTRIBUTION:
During reassembly, install new cover plate gasket. Active Army: To be distributed In accordance with DA Form 12-
To fill shift unit, use pump type oil can. Fill until oil 25A, (qty rqr block no. 121) Operator maintenance requirements for Fire
flows from fill opening. Fighting.
Marine Corps: MARCORPS LIST: AO plus 7000161 (2)

LO5-4210-217-12
 The Metric System and Equivalents

Linear Measure Liquid Measure

1 centiliter = 10 milliters = .34 fl. ounce

1 centimeter = 10 millimeters = .39 inch 1 deciliter = 10 centiliters = 3.38 fl. ounces
1 decimeter = 10 centimeters = 3.94 inches 1 liter = 10 deciliters = 33.81 fl. ounces
1 meter = 10 decimeters = 39.37 inches 1 dekaliter = 10 liters = 2.64 gallons
1 dekameter = 10 meters = 32.8 feet 1 hectoliter = 10 dekaliters = 26.42 gallons
1 hectometer = 10 dekameters = 328.08 feet 1 kiloliter = 10 hectoliters = 264.18 gallons
1 kilometer = 10 hectometers = 3,280.8 feet
Square Measure
Weights
1 sq. centimeter = 100 sq. millimeters = .155 sq. inch
1 centigram = 10 milligrams = .15 grain 1 sq. decimeter = 100 sq. centimeters = 15.5 sq. inches
1 decigram = 10 centigrams = 1.54 grains 1 sq. meter (centare) = 100 sq. decimeters = 10.76 sq. feet
1 gram = 10 decigram = .035 ounce 1 sq. dekameter (are) = 100 sq. meters = 1,076.4 sq. feet
1 decagram = 10 grams = .35 ounce 1 sq. hectometer (hectare) = 100 sq. dekameters = 2.47 acres
1 hectogram = 10 decagrams = 3.52 ounces 1 sq. kilometer = 100 sq. hectometers = .386 sq. mile
1 kilogram = 10 hectograms = 2.2 pounds
1 quintal = 100 kilograms = 220.46 pounds Cubic Measure
1 metric ton = 10 quintals = 1.1 short tons
1 cu. centimeter = 1000 cu. millimeters = .06 cu. inch
1 cu. decimeter = 1000 cu. centimeters = 61.02 cu. inches
1 cu. meter = 1000 cu. decimeters = 35.31 cu. feet

Approximate Conversion Factors

To change To Multiply by To change To Multiply by

inches centimeters 2.540 ounce-inches Newton-meters .007062

feet meters .305 centimeters inches .394
yards meters .914 meters feet 3.280
miles kilometers 1.609 meters yards 1.094
square inches square centimeters 6.451 kilometers miles .621
square feet square meters .093 square centimeters square inches .155
square yards square meters .836 square meters square feet 10.764
square miles square kilometers 2.590 square meters square yards 1.196
acres square hectometers .405 square kilometers square miles .386
cubic feet cubic meters .028 square hectometers acres 2.471
cubic yards cubic meters .765 cubic meters cubic feet 35.315
fluid ounces milliliters 29,573 cubic meters cubic yards 1.308
pints liters .473 milliliters fluid ounces .034
quarts liters .946 liters pints 2.113
gallons liters 3.785 liters quarts 1.057
ounces grams 28.349 liters gallons .264
pounds kilograms .454 grams ounces .035
short tons metric tons .907 kilograms pounds 2.205
pound-feet Newton-meters 1.356 metric tons short tons 1.102
pound-inches Newton-meters .11296

Temperature (Exact)

°F Fahrenheit 5/9 (after Celsius °C

temperature subtracting 32) temperature
PIN: 030056-000
This fine document...

Was brought to you by me:

Liberated Manuals -- free army and government manuals

Why do I do it? I am tired of sleazy CD-ROM sellers, who take publicly

available information, slap “watermarks” and other junk on it, and sell it.
Those masters of search engine manipulation make sure that their sites that
sell free information, come up first in search engines. They did not create it...
They did not even scan it... Why should they get your money? Why are not
letting you give those free manuals to your friends?

I am setting this document FREE. This document was made by the US

Government and is NOT protected by Copyright. Feel free to share,
republish, sell and so on.

I am not asking you for donations, fees or handouts. If you can, please
provide a link to liberatedmanuals.com, so that free manuals come up first in
search engines:

<A HREF=http://www.liberatedmanuals.com/>Free Military and Government Manuals</A>

– Sincerely
Igor Chudov
http://igor.chudov.com/
– Chicago Machinery Movers