Physics Practical Question Paper
Physics Practical Question Paper
AISSCE 2023-2024
PRACTICAL EXAMINATION.
CLASS: XII MAXIMUM MARKS: 30
SUBJECT: PHYSICS (042) TIME: 3 HOURS
GENERAL INSTRUCTIONS:
TOTAL 30 MARKS
SECTION–A
Experiments:
1. To determine resistivity of two / three wires by plotting a graph for potential difference versus
current.
OR
To verify the laws of combination (parallel) of resistances using a metre bridge.
5. To convert the given galvanometer (of known resistance and figure of merit) into a voltmeter of
desired range and to verify the same.
OR
To convert the given galvanometer (of known resistance and figure of merit) into an ammeter of
desired range and to verify the same.
6. To find the frequency of AC mains with a sonometer.
Activities:
1. To measure the resistance and impedance of an inductor with or without iron core.
2. To measure resistance, voltage (AC/DC), current (AC) and check continuity of a given circuit
using multimeter.
6. To draw the diagram of a given open circuit comprising at least a battery, resistor/rheostat, key,
ammeter and voltmeter. Mark the components that are not connected in proper order and correct
the circuit and also the circuit diagram.
SECTION-B
Experiments:
1. To find the value of v for different values of u in case of a concave mirror and to find the focal
length.
2. To find the focal length of a convex mirror, using a convex lens.
3. To find the focal length of a convex lens by plotting graphs between u and v or between 1/u and
1/v.
4. To find the focal length of a concave lens, using a convex lens.
5. To determine angle of minimum deviation for a given prism by plotting a graph
7. To find the refractive index of a liquid using convex lens and plane mirror.
8. To find the refractive index of a liquid using a concave mirror and a plane mirror.
9. To draw the I-V characteristic curve for a p-n junction diode in forward and reverse bias.
Activities:
1. To identify a diode, an LED, a resistor and a capacitor from a mixed collection of such items.
2. Use of multimeter to see the unidirectional flow of current in case of a diode and an LED and
check whether a given electronic component (e.g., diode) is in working order.
3. To study effect of intensity of light (by varying distance of the source) on an LDR.
4. To observe refraction and lateral deviation of a beam of light incident obliquely on a glass slab.
6. To study the nature and size of the image formed by a (i) convex lens, or (ii) concave mirror, on a
screen by using a candle and a screen (for different distances of the candle from the lens/mirror).
7. To obtain a lens combination with the specified focal length by using two lenses from the given
set of lenses.
_________________________________ __________________________________