, Computer Engineering, Electrical, Electronics and Communication Engineering, Geotechnical Engineering,

The papers should be original and comprise previously unpublished research. Submission of manuscript implies
that the same is not being considered for publication elsewhere.
All manuscripts are subject to rapid peer review and those of high quality will be published without delay.
Online submission of the manuscript is strongly recommended. Submit manuscript in the “Submit
Manuscript” button or submit through direct mail on [email protected] or [email protected] . A
manuscript number will be mailed to the corresponding author within 24 Hr.
During submission of the article, the author (s) should be included having

 Authors full address, email id and telephone/fax number.

 The corresponding author should mention the undertaking that the manuscript has not been published
elsewhere (except in the form of an abstract or as part of a published lecture or academic thesis).

Preparation of Manuscript
The manuscript should be prepared in English using “MS Word”, with 1inch margin on all sides (Top, Bottom,
Left and Right side) of the page. “Times New Roman” font should be used. The font size should be
of 12pt throughout the Manuscript, Title Should be 14pt. All research articles should be typed 1.5 spacing and
should have the following sections:
Title page, Abstract, Key words, Introduction, Materials and methods,
Results and Discussion, Conclusion, Acknowledgment (if any) and References.

Title Page
The title should appear on a separate page which should then followed by the author name and the institution
name and address by indicating suitable superscripts.

 The full title of the paper without abbreviations.

The title should be as brief and informative as possible, specifying clearly the content of the article.

 Full names of authors and their affiliations, of all authors indicating the corresponding author in astriek
mark (*).
 Corresponding author contact information (address, telephone, e-mail).
o Paper Title: CAPITAL LETTERS. 14 point type, Bold
o Author(s): First Letter Capital, 12point type, Bold
o Affiliation(s):Word case, 12 point type (Times Roman)
 Corresponding author has the responsibility to ensure that all co authors are aware and approve the
contents of the submitted manuscript.

Abstract
Should start on a new page after the title page and should be typed in single-space to distinguish it from the
Introduction and it should not exceeding 250 words.

Key Words
Provide 4 to 6 appropriate key words after abstract. These keywords should be typed at the end of the abstract.

Introduction
It should be a concise statement of the background to the work presented, including relevant earlier work,
suitably referenced. It should be started in a separate page after abstract

Materials and Methods

All important materials and equipments, the manufacturer’s name and, if possible, the location should be
provided. The main methods used shall be briefly described, citing references. New methods or substantially
modified methods may be described in sufficient detail. The statistical method and the level of significance
chosen shall be clearly stated

Results and Discussion

The important results of the work should be clearly stated and illustrated where necessary by tables and figures.
Results and discussion may be separate or combined based on the author’s requirement. The statistical
treatment of data and significance level of the factors should be stated wherever necessary. The interpreted
results should be explained clearly in discussions and should relate them to the existing knowledge in the field
as clearly as possible. Tables, Graphs and figures (Illustrations) should be inserted at the appropriate place of
the manuscript and should have appropriate numbers and titles with an explanatory heading. Color photographs
and illustrations (line drawings, halftones, photos, photomicrographs etc) must be clean originals. Those
photographs must be clear and sharp. Digital files are recommended for highest quality reproduction and should
follow the following guidelines.

 300dpi or higher sized to fit journal page

 JPEG, and PDF formats are preferred)
 Acknowledgement (if any)

Conclusions
Concisely summarizes the principal conclusions of the work and highlights the wider implications. This section
should not merely duplicate the abstract.

Acknowledgments
Acknowledgements as well as information regarding funding sources may be provided.

References
References must be cited in the text mentioning the last name of the author and year between parentheses. In
case of single or double author papers refer to authors’ names followed by the year of publication (e.g., Hanson,
1980; Hanson and Langmuir, 1978). For multiple author papers, name of the first author should be followed by
“et al.” (e.g., Ashwal et al., 1998). Arrange all the references (cited in the text) at the end of the manuscript
under the heading “References” in alphabetical order in the following style.

Journals

 Kacena W J and Jones P J (1976), “Fatigue prediction of structures subjected to random vibrations”,
Shock and Vibration Bulletin. Vol. 46, No. 3, pp. 87-96.
 Crocker M J (2002), “The Vibroacoustic Environment of Spacecraft During Launch and Flight”. Sound
and Vibration, Vol. 36, No. 6, pp. 5.

Books

 Nakasone Y, Yoshimoto S and Stolarski T A (2006), Engineering Analysis with ANSYS Software, 1st
Edition, Elsevier Butterworth-Heinemann
 Stepanoff A J (1992), Centrifugal and Axial Flow Pumps, 2nd Edition, John Wiley & Sons.

Journal Article in Press

 DASILVA E J (1998). “Machining Metal Matricx Composites”, Met.Mater., Vol.6, In press.

Tables
Tables should be typed on a separate page and must be numbered with Arabic numerals in the order in which
they are cited in the text. They should have a brief descriptive title placed at the top. Footnotes can be included
below the table. Table caption should be 12 point
 S. No. Title Title Title Title

Figures
Should be inserted within the text at appropriate place. All figures must be referred to in the text and numbered
with Arabic numerals in the sequence in which they are cited. Each figure must be accompanied by a legend
explaining in detail the contents of the figure and are to be typed under the figures.

Legends/Captions for figures

Text type should be 12 point Times Roman italic (eg; Figure 1. Caption). A caption should be provided for each
figure. The legend should be typed into the manuscript, directly beneath the figure. Legends are to be listed in
numerical order, labeled as “Figure 1”, “Figure 2”, etc.

Review Article
Organization of the review article is at the author’s discretion and must be at a length of 3000 words excluding
references and abstract. Abstract and key words are required. Tables, figures, illustrations and references are to
be arranged according to research papers.

Copyright
Submission of the manuscript represent that the manuscript has not been published previously and is not
considered for publication elsewhere. Corresponding author would be required to sign a CRA form (Copy Right
Assignment) once the manuscript is accepted which would be sent to the corresponding author’s email. The
corresponding author can download the form sign it and can be send as an attachment file through email along
with the publication charges.

Manuscript Charges
As this is an open access journal and if the manuscript is accepted for publication, the authors has to pay Rs.
1500/- per manuscript (Indian Authors) or US dollar $60 per manuscript (Foreign Authors) towards
processing, reviewing, publishing and ePrints and this may be intimated within one week from the date of
manuscript submission. The modes of fee payment will also be intimated in the acceptance letter.

Plagiarism
Plagiarism is a serious issue around the world in the arena of manuscript writing. Plagiarism means “the
unauthorized use or close imitation of the language and thoughts of another author and the representation of the
one's own original work”. This is generally noticed that, authors are simply copying scientific data and
information from the other published papers, which is an awful practice in academic fraternity. Therefore I
request to the all our author(s) please adopt the holistic & pragmatic approach to design the manuscript of
interest. Hence World Journal of Engineering and research& Technology will not be responsible for further
action on Plagiarism issue. The author will be solely responsible for plagiarism issue.

Galley Proofs
Galley proofs would be sent to the corresponding author. It is the responsibility of the corresponding author to
ensure that the galley proofs are to be returned without delay with correction (if any). The authors are
responsible for the contents appeared in their published manuscripts.
Disclaimer
No responsibility is assumed by the publisher for any injury and/or damage to persons or property as a matter of
products liability, negligence or otherwise, or from any use or operation of any methods, products, instructions
or ideas contained in the material herein. The respective individual author(s) are responsible for the facts and
views expressed in their articles. Authors are solely responsible for their manuscripts and data published in the
journals and any mistakes in the published articles. The publisher does not take any such responsibilities.
Copying and reproducing any parts of the published articles should be duly acknowledged, otherwise, it will be
considered as an offence as per international law.

All manuscripts should be in electronic form and sent

to [email protected] or [email protected]
The Editorial board members/referees/reviewers are honorary position where their contributions to the journal
would be acknowledged in each issue.

AUTHOR FEES
This journal charges the following author fees.
Article Submission: 0.00 (INR)
Authors are required to pay zero rupees for an Article Submission never pay Fee as part of the submission
process to contribute to review costs.
If this paper is accepted for publication, you will be asked to pay an Article Publication Fee to cover
publications costs.

Articles from Articles from Articles from

Article category outside India & UK within UK within India

Research article $60 USD �50 GBP Rs 1500

(Original article)

Review Article $60 USD �50 GBP Rs 1500

Short Communication $60 USD �40 GBP Rs 1500