Scribd
Upload
4 views

Servo Tester

The Servo Tester (ACC007) is a versatile tool for control engineers, allowing operation of up to three servos without the need for additional controllers or PC connections. It features a control knob for manual operation, a neutral position test for calibration, and an automatic 'windscreen wiper mode' for back-and-forth movement. The device operates on a 5-6v DC power supply and has a compact design with specific output and signal specifications.

Uploaded by

elect77.infinity
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views

Servo Tester

The Servo Tester (ACC007) is a versatile tool for control engineers, allowing operation of up to three servos without the need for additional controllers or PC connections. It features a control knob for manual operation, a neutral position test for calibration, and an automatic 'windscreen wiper mode' for back-and-forth movement. The device operates on a 5-6v DC power supply and has a compact design with specific output and signal specifications.

Uploaded by

elect77.infinity
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Servo Tester (ACC007)

The Servo Tester is a very useful addition to the toolbox of any control engineer who has the need to work
with servos. It provides all of the necessary signal controls to make the servo operate over its full range of motion.
Simply connect the tester to a 6v power supply (eg battery pack) and plug in your servo to one of the three available
sockets. The servo can then be moved over its full range of motion by turning the control knob back and forth.
There is no need for any other controller or for any link to a PC. The servo tester is all that you need. It can control
up to three servos at the same time (each operating in the same way). As well as moving the servo in response to
control knob turning (Manual mode), the servo tester has two other modes of operation selected by pressing the
"Select" button next to the knob. The second mode is just a "neutral position" test. This makes any attached servo
go to its mid point of travel (good for calibration). The third mode is "windscreen wiper mode". This puts the servo
into automatic mode and makes the servo swing back and forth over its full range of travel just like a car windscreen
wiper. Three LED's above the control knob confirm which mode is selected. The basic specifications are as shown
below:

Specifications
Output Current 14mA (approx)
Weight 6g
Output Signal Type Pulse Width Modulated
0.5ms to 1.5ms
Supply Voltage Min 5v DC
Max 6v DC
Connectors Standard 3 pin
Servo Type
Dimensions (WxDxH) 45 x 30 x 30 (mm)approx

Servo Tester shown connected to our


Standard Servo and 6v Battery pack
(Note: servo, battery pack and cables are
NOT included with the servo tester)

www.pc-control.co.uk/ocart

You might also like