GIVE YOUR LIVING ROOM A NATURAL LOOK

Rustic PATTE
RN

LAMP
Soft tones make your living or outdoor room a relaxing
place, and this rustic lamp contributes to that nicely.

WHAT DO YOU NEED?

• Katia Capri yarn: 3 balls of
Sand 82134
• 3 mm crochet hook
• Metal rings: Ø 30 cm and
Ø 15 cm
• Wool needle with large eye
• Scissors
• Safety screwdriver
• Wire stripper
(or a sharp knife)
• Black electrical cord,
length of your choice
• Flat plug, black
• Lamp fitting, black
• Strain relief, black
• E27 Lamp, 600 lumens

THIS IS HOW YOU MAKE IT

Try out the size of the crochet hook first
and use a different size if necessary. You
crochet with the rope stitch, like this:
make 1 dc, 1 ch, 1 dc around 1 ch =
base stitch. See also the pattern on the
next page.

LAMP
End each round with 1 sl st in the
1st stitch of the round.
HOME DECOR
 TIP!
Immediately weave in all
the ends with the wool needle.
You can barely reach
them later.

over the ring. Pull the yarn through the loop

Rnds 18-20: as Rnd 17.
Rnd 1: crochet 40 ch, join with 1 sl st in (like an sc) with the hook. Join with 1 sl st in
Rnd 21: as Rnd 13.
1st ch. the 1st ch.
Rnds 22-24: as Rnd 21.
Rnd 2: 1 ch, 40 sc, join with 1 sl st in 1st sc. Rnd 43: as Rnd 3.
Rnd 25: as Rnd 21, but crochet 3 ch
Rnd 3: 3 ch, 1 dc in 1st sc, 1 ch, 1 dc in 1st sc, Rnds 44-50: as Rnd 17. Dec from here.
instead of 2 ch between the dc now.
rep (1 dc, 1 ch, 1 dc in 4th sc), join. Rnd 51: 3 ch, rep (1 dc, 1 ch, 1 dc, crochet
Rnd 26: as Rnd 16.
Rnd 4: rep Rnd 3, but work around in the next ch: 1 dc, 1 ch, 1 dc, make 1 dc in
Rnds 27-33: as Rnd 17.
the ch of the previous round and join. the next ch). Join with 1 sl st.
Rnd 34: 3 ch, rep (1 dc, 1 ch, 1 dc around
Rnds 5-12: as Rnd 4. Rnd 52: 3 ch, rep (1 dc, 1 ch, 1 dc in 1 ch,
1 ch, work around 2nd ch: 1 dc,
Rnd 13: as Rnd 4, but crochet 2 ch crochet in the next ch: 1 dc, 1 ch, 1 dc,
1 ch, 1 dc, 1 ch), end with 1 sl st.
instead of 1. skip 1 dc). Join with 1 sl st.
Rnds 35-37: as Rnd 17.
Rnd 14: as Rnd 13. Rnds 53-55: as Rnd 17.
Rnds 38-41: as Rnds 34-36.
Rnd 15: 3 ch, rep (1 dc, 3 ch, Rnd 56: take the 15 cm Ø metal ring and
Rnd 42: Take the metal ring of 30 cm Ø and
1 dc around the 2 ch), join with 1 sl st. work as Rnd 42.
crochet in 1 ch: 1 sc on each stitch of the
Rnd 16: 3 ch, rep (1 dc, 1 ch, 1 dc, 1 ch, Rnd 57: 1 ch, 1 sc on 1 sc, join with 1 sl st.
previous round (= 1 sc in 1 dc, 1 sc around
1 dc around the 3 ch), join with 1 sl st. Fasten off the last thread and use the wool
the ch, 1 sc in 1 dc). Insert the hook into the
Rnd 17: 3 ch, 1 dc, 1 ch, 1 dc around needle to carefully weave it through a few
stitch of the previous round, the yarn goes
each ch, join. stitches on the inside. Break the yarn.
PATTERN

TIP!
Crochet several lamps, in
different colors if desired,
and hang them together
at uneven heights.

Rope stitch

FINISHING through the narrow part of the lamp

Reinforce the work with fabric stiffener cover. Pull the cord as far as you like and the work will slightly sag when it hangs.
spray, this step is optional. determine the height of the bulb in the Wind the cord around a stick or hang
lamp. Cut a long strand of the yarn and several lamps from the ceiling at
ELECTRICAL PARTS tightly pull the narrow part upward. different heights. Finally, screw in
Attach the plug to one end of the cord Use the yarn to tightly tie and wrap the light bulb.
and the strain relief with fitting to the the lamp you made to secure it at about
other end. Insert the plug from the inside 28 cm from the fitting. Keep in mind that