Scribd
Upload
27 views5 pages

Giu 2512 64 19895 2024-10-20T07 51 02

The document outlines the lab instructions for ENGN 112: Electrical Engineering and Electronics, focusing on RC circuits. It includes a checklist for students, details on connecting circuits using a function generator and oscilloscope, and tasks for both practical and analytical calculations. Students are required to generate and analyze waveforms while ensuring proper setup and component functionality.

Uploaded by

mohamed.w.zoher
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
27 views5 pages

Giu 2512 64 19895 2024-10-20T07 51 02

The document outlines the lab instructions for ENGN 112: Electrical Engineering and Electronics, focusing on RC circuits. It includes a checklist for students, details on connecting circuits using a function generator and oscilloscope, and tasks for both practical and analytical calculations. Students are required to generate and analyze waveforms while ensuring proper setup and component functionality.

Uploaded by

mohamed.w.zoher
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Electrical Engineering Department

Dr. Muhammad Othman


Winter 2024

ENGN 112: Electrical Engineering and Electronics


Lab (4)
Title: RC Circuits Score: / 100
Tutorial number:

Student Name Student ID

Date:

Practical Connections / 40

Results / 40

Report / 20

Total / 100

❑ Comments:

Check list:
 Cover Page
 Results (Lab-sheet and extra graphs and/or tables, if necessary) 
Appendix #1 (Post-Lab)

( Good Luck ☺ )
Electrical Engineering Department
Dr. Muhammad Othman
Winter 2024

Using the available components in the lab, connect the following circuits. Make sure to properly
adjust the settings of both the function generator and the Oscilloscope, and to double check the
components values prior to connecting them. Use the proper connection for the three-terminal
potentiometer. It’s your responsibility to make sure that all components, wires, and measuring
instruments are not faulty.

E1) 1) Use the function generator to generate a square wave with 10 v peak to peak (Vpp), adjust
the offset voltage so that the square wave varies from 0 to 10 then use the oscilloscope to view the
output and sketch it to scale below.
Electrical Engineering Department
Dr. Muhammad Othman
Winter 2024

2) Connect the circuit in the figure above, where the voltage source in the figure should be the
function generator and it should be adjusted as stated in 1, then connect the two channels of the
oscilloscope to nodes 1 and 2 in the circuit and plot the output to scale below. (Hint: shift the output
of both channels to align them on the x-axis (in the center))

3)Build the same circuit again in LTspice, use transient analysis to plot the same graph as part2,

4)Calculate analytically and fill it in the table


Variable Calculation Simulation

τ RC
Electrical Engineering Department
Dr. Muhammad Othman
Winter 2024

Waveform of 𝑣𝑐 while charging:

Waveform of 𝑣𝑐 while discharging:


Electrical Engineering Department
Dr. Muhammad Othman
Winter 2024

You might also like