Scribd
Upload
6 views

##UPCAM USAGE--UPCAM培训流程

Uploaded by

sid.dental.marketing
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views

##UPCAM USAGE--UPCAM培训流程

Uploaded by

sid.dental.marketing
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

1.

Setting NC saving folder:set suitable NC file saving position by yourself

2.Blanks You can add the material as needed

1.Choose the milling machine and material.

2.Finding STL file and double click,choose the restoration type and cnfirm.
3.New order
3.According to your requirement to choose suitable blank.

4.If you choose a new block,you need to input the order name and scale follow the block information.

1.Pay attention the "milling area" when you nesting the long bridge.
4.Set
2.The update version will generate automatically.

1.One-point direction:Choose this function,then click the margin position of the teeth,it will generate automatically
Add
2.Lesso direction:Drawing margin by yourself
5.Margin machine
1.Draw a degment line:Adjust margin by drawing points
Edit
2.Control points:Set some points,then we can move the point position to change the margin

Move You can press the left mouse and drag teeth to a suitable position on block

6.Position 1.Open "Show rotation aixs" and “A axis" & "B axis"
UPCAM USAGE Rotate
2.After we rotate the teeth,we need to double check the angulation

1.You can drag the arrow to adjust the insertion

2.Pay attention to the red area in coping,it means undercut


7.Insert direction
3.You‘d better choose "Optimized insertion direction"normally

The angle of the insertion no more than 20 degree

Add&Delete&Reset

Cylinder Default type


8.Pin Type
Taper You can also choose this type and modify value by yourself

Adjust
Diameter Default type is 2mm.It usually needn't adjusted.But for long bridge with stabilizer,you 'd better adjust it to 2.5-3.0mm

Cut depth When teeth mill finished,machine will mill pins so that make it become thiner.

1.Stablizer for certical direction


9.Drops(for long bridge)
2.Keep the long bridge stability when sintering

10.Stablizer(for long bridge) Ensure that teeth don't deform during sintering

Generate:After adjust finished,choose a suitable way to


11.Toolpath generate

You might also like