Scribd
Upload
13 views

Megger Guide to Insulation Testing 2

The document discusses the importance of monitoring insulation resistance to prevent equipment failure, particularly in motors, which can become dangerous if insulation deteriorates. It explains that insulation resistance can be measured using a Megger insulation tester, which provides direct readings and is non-destructive. Regular checks can help identify issues early, allowing for planned maintenance before service failure occurs.

Uploaded by

Dedy hermawan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
13 views

Megger Guide to Insulation Testing 2

The document discusses the importance of monitoring insulation resistance to prevent equipment failure, particularly in motors, which can become dangerous if insulation deteriorates. It explains that insulation resistance can be measured using a Megger insulation tester, which provides direct readings and is non-destructive. Regular checks can help identify issues early, allowing for planned maintenance before service failure occurs.

Uploaded by

Dedy hermawan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Once started, the different enemies tend to aid each other, permitting

excessive current through the insulation.

Sometimes the drop in insulation resistance is sudden, as when equipment


is flooded. Usually, however, it drops gradually, giving plenty of warning,
if checked periodically. Such checks permit planned reconditioning before
service failure. If there are no checks, a motor with poor insulation, for
example, may not only be dangerous to touch when voltage is applied,
but also be subject to burn out. What was good insulation has become a
partial conductor.

How Insulation Resistance is Measured

You have seen that good insulation has high resistance; poor insulation,
relatively low resistance. The actual resistance values can be higher or lower,
depending upon such factors as the temperature or moisture content of the
insulation (resistance decreases in temperature or moisture). With a little
record-keeping and common sense, however, you can get a good picture of
the insulation condition from values that are only relative.

The Megger insulation tester is a small, portable instrument that gives you
a direct reading of insulation resistance in ohms or megohms. For good
insulation, the resistance usually reads in the megohm range.

The Megger insulation tester is essentially a high-range resistance meter


(ohmmeter) with a built-in direct-current generator. This meter is of special
construction with both current and voltage coils, enabling true ohms to be
read directly, independent of the actual voltage applied. This method is non-
destructive; that is, it does not cause deterioration of the insulation.

Figure 2–Typical Megger test instrument hook-up to measure insulation resistance.

A STITCH IN TIME 5

You might also like