DAQe-2000 Series Datasheet en 20170808 v1
DAQe-2000 Series Datasheet en 20170808 v1
PXI/DAQ/DAQe-2000 Series
4-CH 14/16-Bit Up to 2 MS/s Simultaneous-Sampling DAQ Cards
PXI/DAQ/DAQe-2010 4-CH DI 14 Bit 2 MS/s ±1.25 V to ±10 V 2 12 Bit 1 MS/s 24-CH 8255 PIO 2-CH, 16-Bit
PXI/DAQ/DAQe-2005 4-CH DI 16 Bit 500 kS/s ±1.25 V to ±10 V 2 12 Bit 1 MS/s 24-CH 8255 PIO 2-CH, 16-Bit
PXI-2010
PXI/DAQ/DAQe-2006 4-CH DI 16 Bit 250 kS/s ±1.25 V to ±10 V 2 12 Bit 1 MS/s 24-CH 8255 PIO 2-CH, 16-Bit
Specifications
Model Name PXI/DAQ/DAQe-2010 PXI/DAQ/DAQe-2005 PXI/DAQ/DAQe-2006
Analog Input
Resolution 14 Bit 16 Bit, no missing codes 16 Bit, no missing codes
Number of channels 4 simultaneous-sampling channels with differential input
Maximum sampling rate 2 MS/s 500 kS/s 250 kS/s
Programmable gain 1, 2, 4, 8
DAQ-2010
Bipolar input ranges ±10 V, ±5 V, ±2.5 V, ±1.25 V
Unipolar input ranges 0-10 V, 0-5 V, 0-2.5 V, 0-1.25 V
Offset error ±3 mV 2 mV ±1 mV
Gain error ±0.1% of FSR ±0.04% of FSR ±0.03% of FSR
Input Coupling DC
Overvoltage protection Power on: Continuous ±35 V, Power off: Continuous ±15 V
Input Impedance 1 GΩ/100 pF
Trigger sources Software, external digital/analog trigger, SSI bus
Trigger modes Pre-trigger, post-trigger, middle-trigger, delay-trigger, and repeated trigger
FIFO buffer size 8 k samples 512 samples 512 samples
DAQe-2010 Data transfers Polling, scatter-gather DMA
Analog Output
Number of channels 2 voltage outputs
Resolution 12 Bit
Output ranges 0-10 V, ±10 V, 0-AOEXTREF, ±AOEXTREF
Features Maximum update rate 1 μs
Slew rate 20 V/μs
■ Supports a 32-Bit 3.3 V or 5 V PCI bus (DAQ-2000 series)
Settling time 3 μs to ±0.5 LSB accuracy
■ x1 lane PCI Express® Interface (DAQe-2000 series) Offset error ±3mV ±1mV ±1mV
■ PXI specification Rev. 2.2 compliant (PXI-2000 series) Gain error ±0.05% of max. output ±0.04% of max. output ±0.04% of max. output
Driving capacity 5 mA
■ 4-CH differential analog inputs
Stabililty Any passive load, up to 1500 pF
■ Bipolar or unipolar analog input ranges Trigger sources Software, external digital/analog trigger, SSI bus
■ Programmable gains of x1, x2, x4, x8 Trigger modes Post-trigger, delay-trigger, and repeated trigger
■ Scatter-gather DMA for both analog inputs and outputs FIFO buffer size 2 k samples
Data transfers Programmed I/O, scatter-gather DMA
■ 2-CH 12-Bit multiplying analog outputs with waveform
Digital I/O
generation Number of channels 8255 24-Bit programmable input/output
■ 24-CH TTL digital input/output Compatibility 5 V/TTL
■ 2-CH 16-Bit general-purpose timer/counter Data transfers Programmed I/O
Timer/Counter
■ Analog and digital triggering Number of channels 2
■ Fully auto calibration Resolution 16 Bit
■ Multiple cards synchronization through SSI (System Compatibility 5 V/TTL
Base clock available 40 MHz , external clock up to 10 MHz
Synchronization Interface) bus or PXI trigger bus
General Specifications
■ Supported Operating System Auto Calibration Yes (+5 V, ±2 ppm/˚C)
Dimensions 160 mm x 100 mm (not including connectors) (PXI-2000 series)
• Windows 7/8 x64/x86, Linux 175 mm x 107 mm (not including connectors) (DAQ-2000 series)
168 mm x 107 mm (not including connectors) (DAQe-2000 series)
■ Driver and SDK
Connector 68-pin VHDCI-type female
• LabVIEW, MATLAB, C/C++, Visual Basic, Operating temperature 0˚C to 55˚C (32˚F to 131˚F )
Storage temperature -20˚C to 70˚C (-4˚F to 158˚F)
Visual Studio.NET Humidity 5 to 95%, non-condensing
Power requirements +5 V 1.82 A typical (PXI/DAQ-2010) +5 V 2.04 A typical (PXI/DAQ-2005) +5 V 1.82 A typical (DAQ-2006)
■ Software Utility
+3.3 V 1.246 A, +12 V 0.448 A +3.3 V 1.03 A, +12 V 0.75 A +3.3 V 1.02 A, +12 V 0.67 A
• AD-Logger typical (DAQe-2010) typical (DAQe-2005) typical (DAQe-2006)
■ ACL-10568-1
■ ACL-SSI-2/3/4
* For more information on mating terminal board and cables, please
refer to P3-48/49.
Updated September 23, 2014. ©2014 ADLINK Technology, Inc. All Rights Reserved. All specifications are subject to change without further notice. www.adlinktech.com 3-20