Scribd
Upload
9 views4 pages

ECA experiment 5 lab manual

The document outlines an experiment to verify the superposition theorem in an electric circuit analysis laboratory. It includes the aim, required apparatus, precautions, procedure, and a tabular column for recording theoretical and practical values. The superposition theorem states that in a linear bilateral network with multiple sources, the total current in a branch is the sum of the currents from each source considered individually.

Uploaded by

Dharshan B G
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views4 pages

ECA experiment 5 lab manual

The document outlines an experiment to verify the superposition theorem in an electric circuit analysis laboratory. It includes the aim, required apparatus, precautions, procedure, and a tabular column for recording theoretical and practical values. The superposition theorem states that in a linear bilateral network with multiple sources, the total current in a branch is the sum of the currents from each source considered individually.

Uploaded by

Dharshan B G
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Electric circuit analysis laboratory (BEE302) _ Laboratory IPCC

Experiment 5
VERIFICATION OF SUPERPOSITION
THEOREM

Aim:
To verify the superposition theorem for the given circuit.

APPARATUS REQUIRED:
Sl.No Name of the Apparatus Range Quantity
1. RPS (regulated power supply) (0-30V) 2
2. Ammeter (0-10mA) 1
3. Resistors 1k, 330, 220 3
4. Bread Board -- --
5. Wires -- Required

Statement:

Superposition theorem states that in a linear bilateral network containing more than one
source, the current flowing through the branch is the algebraic sum of the current flowing through
that branch when sources are considered one at a time and replacing other sources by their
respective internal resistances.

Precautions:

1. Voltage control knob should be kept at minimum position


2. current control knob of RPS should be kept at maximum position

Procedure:
1. Give the connections as per the diagram.
2. Set a particular voltage value using RPS1 and RPS2 & note down the
ammeterreading
3. Set the same voltage in circuit I using RPS1 alone and short circuit the
terminalsand note the ammeter reading.
4. Set the same voltage in RPS2 alone as in circuit I and note down the
ammeterreading.
5. Verify superposition theorem

Dept. Of EEE VVIET Prepared By: Dharshan B G


Electric circuit analysis laboratory (BEE302) _ Laboratory IPCC

Circuit Diagram:

CIRCUIT - 1

CIRCUIT - 2

CIRCUIT - 3

Dept. Of EEE VVIET Prepared By: Dharshan B G


Electric circuit analysis laboratory (BEE302) _ Laboratory IPCC

Tabular Column:

Theoretical Values

RPS Ammeter Reading


1 2 (I)mA
Circuit – 1

Circuit – 2

Circuit – 3

I = I’  I” =
Practical
Values

RPS Ammeter Reading


1 2 (I)mA
Circuit – 1

Circuit – 2

Circuit – 3

I = I’  I” =
=

Model Calculations:

RESULTS:

Dept. Of EEE VVIET Prepared By: Dharshan B G


Electric circuit analysis laboratory (BEE302) _ Laboratory IPCC

Dept. Of EEE VVIET Prepared By: Dharshan B G

You might also like