Scribd
Upload
2 views

Extracted pages from In-Cass Test 2

The document outlines a modeling and assembly task involving various parts such as a bracket, pivot, and bushing, with specific instructions for drawing and mass calculation. It includes sections for part modeling, assembly modeling, and an essay writing component that requires suggestions for applications, alternative materials, and design improvements. Each question is allocated specific marks, indicating the importance of each task.

Uploaded by

krem jamboy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2 views

Extracted pages from In-Cass Test 2

The document outlines a modeling and assembly task involving various parts such as a bracket, pivot, and bushing, with specific instructions for drawing and mass calculation. It includes sections for part modeling, assembly modeling, and an essay writing component that requires suggestions for applications, alternative materials, and design improvements. Each question is allocated specific marks, indicating the importance of each task.

Uploaded by

krem jamboy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

Section A: Part Modelling

Question 1

Draw the parts accordingly based on the figures shown below:

Figure 1: Bracket (10 marks)

4 | Page
Figure 2: Pivot (10 marks)

5 | Page
425

Figure 3: U-Support (10 marks)

Figure 4: Bushing (10 marks)

6 | Page
Figure 5: Nut #1 (5 marks)

Figure 6: Washer (5 marks)

7 | Page
Figure 7: Bolt (5 marks)

Figure 8: Nut #2 (5 marks)

8 | Page
Section A: Part Modelling

Question 2 - Find the mass for all parts. (10 marks)

Part Name Material Mass (gram)

AISI Type 316L


Bracket
Stainless Steel
AISI Type 316L
Pivot
Stainless Steel
AISI Type 316L
U-Support
Stainless Steel
AISI Type 316L
Bushing
Stainless Steel
Nut #1 Cast Stainless Steel

Washer Cast Stainless Steel

Bolt Cast Stainless Steel

Nut #2 Cast Stainless Steel

9 | Page
Section B: Assembly Modelling

There is 1 question in this section.

Question 3 (15 marks)

Create the assembly as shown in Figure 9.

Use Figure 10 as reference to know how to assemble all the parts together. You do NOT need to create
this exploded view.

Note: The Bracket, Pivot and U-Support should be able to rotate

Figure 9: Model Assembly

1: Bracket
2: U-Support
3: Pivot
4: Bushing
5: Nut #1
6: Washer
7: Bolt
8: Nut #2

10 | Page

Figure 10: Exploded View of Model


Section C: Essay Writing

There is 1 question in this section

Question 4 (15 marks)

Write an essay (minimum 1000 words) explaining the following:

1) Suggest an application for this Model and explain your reasons why.

2) Suggest a different material for all the 8 parts and explain why you have chosen those materials
for your application.

3) Suggest a better alternative to the design of this Model and explain your reasons why.

Use Arial Font, Size 12

THE END

11 | Page

You might also like