1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

A A

2750
106 19 PALES AT 141mm CENTRES 106

DANGER OF DEATH NOTICE.

FOR DETAILS REFER TO
DANGER OF DEATH DETAIL
DANGER OF DEATH 'KEEP OUT' SIGN
TYPICALLY EVERY 3RD PANEL OR MAX 10MTR INTERVAL DANGER OF DEATH
'KEEP OUT' SIGN

285
315
(SEE DETAIL)
B TOP OF RAIL B
DANGER OF DEATH NOTICE LOCATION PLAN
DANGER OF DEATH
KEEP OUT

50x50x6 UKA
RAIL (TYPICAL)
NOTES
PALES
HOT ROLLED SLIT COIL S275 BS EN 10025:1993 4mm THICK & 79mm WIDE, THIS IS THEN COLD
127x76x13 UKB FORMED INTO 'D' SECTION PALES 19 No PER STANDARD PANEL (2750mm POST CENTRES). THE
127x76x13 UKB 150 x 30 x 3mm
FENCE POST PALES ARE HOLED TO SUIT SPECIFICATION AND ARE LOCKED INTO POSITION BY MEANS OF M8 x
FENCE POST GALVANISED STEEL
3925mm LONG 25mm BOLTS & M8 ANTI-VANDAL NUTS.
CLAMPING PLATE
C C

2060
2060

INTERMEDIATE AND CORNER POSTS

127x76x13 UKB 3925mm LONG POINTED AT TOP AND SLOTTED TO ACCOMMODATE FISHPLATES

3000

3000
3050

AND TO ALLOW THE INSTALLATION OF A CABLE CONDUIT ALONG THE TOP RAIL.

3050
'D' SHAPED HORIZONTAL SUPPORT RAILS
YELLOW

3925mm POST LENGTH

FENCE PALES 50mm x 50mm x 6mm RSA TO BS EN 10025-1 GRADE S275. HORIZONTALS HAVE 'V' SHAPED
SLOTS ON THE TOP FLANGE TO ACCOMMODATE INSERTION OF THE PALES AND HAVE 10mm
DIAMETER HOLES WHICH HAVE A 21mm DIAMETER COUNTERBORE ON THE FRONT FACE
BLACK
ALLOWING THE M8 BOLTS TO PASS THROUGH.

INTERMEDIATE RAIL SUPORTS

OPTIONAL RABBIT PROOF PERIMETER FOOTPATH INTERNAL COMPOUND
D REFER TO FISHPLATE 30mm x 10mm FLAT FIXED BETWEEN THE 6TH & 7TH PALE FROM D
GALVANISED 358 MESH. SURFACED WITH 50mm TOP OF RAIL SURFACED WITH 75mm
CONNECTION DETAIL 30 x 40mm SLOT EITHER END & BOLTED TO THE BOTTOM RAIL.
ONLY TO BE INSTALLED APPROVED 6-10mm GRADED APPROVED 14-20mm
WHERE REQUESTED. FOR MICROPHONIC
AGGREGATE, ON 100mm GRADED AGGREGATE, ON BLACK FIXINGS
CABLE CONDUIT
DANGER OF DEATH

400
REFER TO DRG SP4135429
400

MAX 50mm
TYPE 1 ON AN APPROVED 225mm APPROVED M12 X 30mm CUP SQUARE BOLTS & M12mm SHEAR NUTS FOR FIXING THE RAILS TO THE POSTS

MAX 50mm
FOR DETAILS. GEOTEXTILE MEMBRANE SUB-BASE 150 x 30 x 3mm & AT CENTRE REST POINTS M8 X 25mm CUP, SQUARE BOLTS & M8 SHEAR NUTS FOR FIXING
SUBSTATION PERIMETER
TOP OF RAIL
GALVANISED STEEL KEEP OUT PALES TO RAILS
SUBSTATION
CLAMPING PLATE

50
255
225

COMPOUND FOOTPATH COMPOUND

ALL THE BOLTS SHOULD THEN BE TIGHTENED UNTIL THE HEXAGONAL HEAD SHEARS OFF THUS
LEAVING A DOME ON EITHER SIDE.

300
250

250
300

50

E POST - TO BS 4 PART 1 AND BS EN 10025-1 GRADE S355 E

GROUND AROUND FOUNDATION

BOLTS AND NUTS - HEXAGONAL TO BS 4190
300mm DEEP MASS 150 X 50 ROUND TOPPED

TO BE FULLY COMPACTED
300mm DEEP MASS GRADE C20/25 CUP AND COUNTERSUNK TO BS 325
EDGING KERB SET ON 300 X
850

CONCRETE CONCRETE ANTI-BURROW CONCRETE COLOURS :- BACKGROUND - YELLOW - TO B.S. 5252 OR B.S. 381C PLAIN WASHER - TO BS 4320 TABLE 4
ANTI-BURROW STRIP 883 984 883 STRIP 100mm ST3 CONCRETE
'Z'

R.H.S. SECTIONS - TO BS 1:2005 OR BS EN 10210-2:1997

'Z'
FOUNDATION AND MATERIAL :-
210x150mm POCKET IN GALVANISING - TO BS EN ISO 1461
HAUNCHING UV STABILISED 0.75mm THICK, LAMINATED, STOVED ALUMINIUM.
CONCRETE FOR POST, COMMODITY CODE : 30981883
AND FILLED WITH SAND/ IN THE EVENT OF THE FENCE BEING USED IN CONJUNCTION WITH AN ELECTRIFIED FENCE, THE
30x10mm FLAT (GRADE S275) FENCE POSTS, UV STABILISED 3mm PVC. COMMODITY CODE : 30981845
CEMENT GROUT WITH CONTRACTOR SHALL ARRANGE TO FIT THE REQUIRED ADDITIONAL SUPPORTS TO THE FENCE
530MM LONG BOLTED TO BOTTOM RAIL AND UV STABILISED SELF ADHESIVE VINYL. COMMODITY CODE : 30982966
CONBEX NON-SHRINK POSTS PRIOR TO THE STEELWORK BEING GALVANISED.
CAST INTO ANTI-BURROW STRIP.
(OSA), MINIMUM NOTE :- SIGNS TO BE CLAMPED TO IN POSITION - DRILLING GALVANISED
F STRENGTH OF GROUT TO PALES IS NOT PERMITTED NON-STANDARD AND CLOSING PANELS F
150x100x10mm THICK BASEPLATE TO POST BE 60N/mm² A STANDARD PANEL DENOTES 2750mm POST CENTRES WITH A 2738mm RAIL LENGTH.
'X'
REFER TO SCOTTISHPOWER DRAWING No. 00033296 FOR FULL DETAILS CLOSING PANEL LENGTHS ARE STANDARD 2738mm RAILS WITH PALES REMOVED TO REDUCE
LENGTH BY FACTORS OF 141mm E.G. 2596, 2455, 2314, 2173 ETC. RAILS FOR
ELEVATION OF STANDARD PANEL FENCE POST AND FOUNDATION CLOSING PANELS TO BE NO LESS THAN

SCALE 1:20 SCALE 1:20

DANGER OF DEATH 1186mm LONG.
AFTER CONSTRUCTION THERE SHOULD BE NO GAP BETWEEN PALES OR BETWEEN PALES & POST
'KEEP OUT' SIGN DETAIL GREATER THAN 76mm

SLOPING PANELS
THE MAXIMUM GRADIENT A FENCE PANEL CAN ACCOMMODATE IS 300mm FALL OVER A SINGLE
2750mm C/C OF INTERMEDIATE FENCE POSTS STANDARD PANEL LENGTH.
G 'D' PALE SLOTTED THROUGH RAILS FOR STEEPER GRADIENT CONTACT THE MANUFACTURER FOR THE FABRICATION OF CUSTOM G
6 2738mm STANDARD RAIL LENGTH 6 STANDARD RAIL LENGTH 2738mm 12 STANDARD RAIL LENGTH 2738mm PANEL

62 30 x 40mm SLOT FOR ACOUSTIC CABLE

20x14 SUNK SLOTTED HOLES CONDUIT ABOVE SECOND RAIL ONLY.
=

MASS CONCRETE ANTI-BURROW STRIP COUNTERSUNK TO ACCEPT

M12 CUP HEAD BOLTS
50x50x6 UKA
FOUNDATION SIZES BASED ON WIND LOADS TO BS EN 1-4 AND
350

'X'

30
WITH 20x14mm DESIGNED TO DMRB - HA 66/95 AND BD 94/07

40
HORIZONTALLY SLOTTED HOLES
=

COUNTERSUNK M12 22
H FENCE POST FOUNDATIONS H

20
47 47 CUP HEAD BOLT 160x40x10mm THICK FISHPLATE
= = = = CONNECTOR Site Elevation Peak Velocity Dimension Dimension Dimension Concrete Push Test
53 53 COUNTERSUNK HOLE
PALE PALE WITH 14mmØ HOLES Force 'X' 'Y' 'Z' Volume Load*
'Y' 'Y' FOR PALE CONNECTION
Up To 100m 0.95 kN/m² 600mm 600mm 1100mm 0.396m³ 17kN
127x76x13 UKB
FENCE POST Up To 200m 1.13 kN/m² 600mm 600mm 1200mm 0.432m³ 20kN
Up To 300m 1.33 kN/m² 700mm 700mm 1300mm 0.637m³ 23kN
PLAN OF STANDARD PANEL Up To 400m 1.55 kN/m² 800mm 800mm 1400mm 0.896m³ 26kN**
SCALE 1:20 FISHPLATE CONNECTION DETAIL FISHPLATE CONNECTION DETAIL
NOTES:-
ELEVATION SECTIONAL VIEW 1. FOUNDATION SIZES ARE ONLY SUITABLE FOR SITES GREATER THAN 1km FROM THE COAST AND NO HIGHER THAN 400m
J J
SCALE 1:5 SCALE 1:5 ABOVE ORDNANCE DATUM (AOD).
2. FOR SITES WITH ELEVATIONS ABOVE 400m OR WITHIN 1km FROM THE COAST, FOUNDATIONS TO BE DESIGNED TO MEET THE
SITE SPECIFIC CONDITIONS.
3. WIND PRESSURE BASED ON Vb, map = 26m/s
2750mm C/C OF INTERMEDIATE FENCE POSTS 4. IT IS ESSENTIAL THAT THE GROUND AROUND THE FOUNDATION IS FULLY COMPACTED TO NO LESS THAN 300mm FROM THE
FINISHED COMPOUND SURFACE.
868 868 5. FOUNDATIONS DESIGNED TO HA 66/95 SHALL, AT THE ENGINEERS REQUEST, BE SUBJECT TO A SELECTION OF PUSHOVER
TESTS IN ACCORDANCE WITH IEC GUIDANCE DOCUMENT.
JOINT TO BE FILLED WITH 12MM 127x76x13 UKB
6. MINIMUM 'X' DIMENSION ON FOUNDATIONS FOR REMOVABLE PANELS IS 1200mm.
COMPRESSIBLE JOINT FILLER AND FENCE POST 7. TOPOGRAPHY HAS BEEN DISCOUNTED IN THE DESIGN.
POLYSULPHIDE MASTIC SEALANT 160 8. * LOAD APPLIED 1m ABOVE FOUNDATION LEVEL
12x50mm SLOT IN UKB TO 160x40x10mm 9. **A SACRIFICIAL 152 x 89 x 16 POST AND FOUNDATION SHOULD BE USED WHEN APPLYING THE PUSH-OVER TEST FORCE
K INTERNAL FACE OF FENCELINE THICK MS FLAT FISHPLATE K
=

ALLOW PASSAGE OF
=

FISHPLATE 6 CONNECTOR
27
170

170

27
210

210

350

'X'

22

4 26/02/2020 AJB DC AM GENERAL UPDATE TO DETAILS

=

ASSOCIATED DRAWINGS 3 05/07/2018 AJB DC AM FOUNDATION SIZES UPDATED AND GROUND CLEARANCE REDUCED TO 50mm
=
50

50

EXTERNAL FACE OF FENCELINE 2 May 2016 SM AJB CR UPDATED AND APPROVED

20x14mm SLOTTED HOLE STANDARD PANEL DETAILS SP4107664
= 150 = = 150 = 140.6 56 47 47 1 18/08/2015 EM AJB AJB RAIL LENGTH UPDATED TO 2738mm
30 954 30 IN UKA COUNTERSUNK CORNER POST AND INSULATED PANEL DETAILS SP4107665
0 ---------- - - - COPIED FROM PREVIOUS NUMBERING SYSTEM
50x50x6 UKA 53 53 FOR M12 CUP HEAD
'Y' 'Y' DOUBLE LEAF GATE FOR ROADS WITH CAMBER SP4107666 Rev. Date Drawn Reviewed Approved Reason / Description of changes.
BOLTS Status Stamp:
DOUBLE LEAF GATE FOR ROADS WITH CROSSFALL SP4107667 Project:
L
PERSONNEL GATE DETAIL SP4107668
3m HIGH ENHANCED SECURITY FENCE L

PLAN OF POCKETS IN FOUNDATIONS FISHPLATE CONNECTION DETAIL FASTENING DETAIL FOR DOUBLE LEAF GATE SP4107669

AND FOUNDATION CONTRACTION JOINTS PLAN VIEW INWARD OPENING HANGING DETAIL FOR DOUBLE LEAF GATE (CAMBER) SP4107670 Location:
TRANSMISSION SUBSTATIONS
SCALE 1:5 INWARD OPENING HANGING DETAIL FOR DOUBLE LEAF GATE (CROSSFALL) SP4107671 Status Stamp: Drg. Title:
SCALE 1:20 OUTWARD OPENING HANGING DETAIL FOR DOUBLE LEAF GATE (CAMBER) SP4107672 3m HIGH LOCHRIN-BAIN COMBI SECURITY FENCE
OUTWARD OPENING HANGING DETAIL FOR DOUBLE LEAF GATE (CROSSFALL) SP4107673
HANGING DETAIL FOR PERSONNEL GATE SP4107674
FASTENING DETAIL FOR PERSONNEL GATE SP4107675 Drawn Rev'd App'd Drg. No.: Sheet: Rev:
REMOVABLE FENCE PANEL DETAILS AND EXTENSION OPTIONS SP4135429 SP4107664 Next: 4
M SPEN Ref. No. : Scale: Size:
M
TYPICAL FENCE AND GATE EARTHING DETAILS SP4135431 #### AS SHOWN A1
All rights reserved. Total or partial reproduction of this drawing without authorisation of the proprietor is prohibited.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16