Scribd
Upload
15 views5 pages

OPTI-Solar-SNMP-guide

The SNMP Manager Quick Guide provides instructions for installation, connection, and configuration of the SNMP manager for UPS systems. It includes steps for connecting Ethernet and sensor ports, configuring IP settings, and monitoring SNMP devices using SolarPower Pro software. Users are advised to consult the SNMP Manager User Manual for detailed configuration and operation instructions.

Uploaded by

Wahib Alaidh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
15 views5 pages

OPTI-Solar-SNMP-guide

The SNMP Manager Quick Guide provides instructions for installation, connection, and configuration of the SNMP manager for UPS systems. It includes steps for connecting Ethernet and sensor ports, configuring IP settings, and monitoring SNMP devices using SolarPower Pro software. Users are advised to consult the SNMP Manager User Manual for detailed configuration and operation instructions.

Uploaded by

Wahib Alaidh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

SNMP Manager Quick Guide

V. 1.0
www.opti-solar.com

1． Overlook

Ethernet port (10/100Base-T)


Sensor port
Golden finger: connects to UPS slot
Ethernet port status LEDs

Ethernet port status LEDs:


100M LED (Green) Flash Port is operating at 100Mbit/s
Off Card is not connected to the network
10M LED (Yellow) Flash Port is operating at 10Mbit/s
Off Card is not connected to the network

2． Installation and Connection


Follow below steps to install and connect the SNMP manager:
Step 1: Remove the cover of intelligent slot on the back panel of UPS and
retain the screws
Step 2: Slide the card into the open slot and secure with the screws from
step 1. (see chart 2-1)

Chart 2-1
Refer to chart 2-2 for connecting the SNMP manager.
www.opti-solar.com

Step 3: Plug Ethernet cable to the Ethernet port (RJ-45) on the SNMP
manager.
Step 4: Use one more Ethernet cable. Connect one end to the sensor port on
the SNMP manager and the other end to the optional environmental
monitoring device.

Chart 2-2
3． Configuration
a) Please install SolarPower Pro monitoring software in your PC. After
software is installed successfully, it will pop up a plug icon in
the tray. SNMP manager will be automatically activated.
Select “SNMP manager” by clicking right button of the mouse.

Chart 3-1
www.opti-solar.com

b) Enter specific IP address to search all SNMP devices in LAN. (The


SNMP manager will automatically collect the IP address from sever by
default via a DHCP server. It will apply default IP address of
192.168.102.230, default subnet mask as 255.255.255.0, and default
gateway as 0.0.0.0 without a DHCP server.

Chart 3-2

c) User can modify IP setting, online upgrade, password management,


and static trap address setting in SNMP Manager interface. It is
necessary to enter password for any medications. The default
password is 12345678.

Please check SNMP Manager User Manual for detailed configuration.


www.opti-solar.com

4. Monitoring
As chart 4-1, select “Open URL” by clicking right button of the mouse.

Chart 4-1
Then, it will activate SolarPower Pro software and list SNMP devices on the left
side of screen. Refer to Chart 4-2.

Chart 4-2

Please check SolarPower Pro software for detailed operation.

You might also like