Mercedes-Benz VEHICLE DIAGNOSTIC REPORT - 4JGFB4KB9NA822044 - 20241028140140
Mercedes-Benz VEHICLE DIAGNOSTIC REPORT - 4JGFB4KB9NA822044 - 20241028140140
Device information
Scanner: MaxiIM IM608 Pro Serial Number: H10PM7V01489
Version: V19.01 Repair Order Number: --
System Scanned ( 49 )
System Status/DTC
KI(Instrument Cluster) 3
PTS(Parking System) 4
LIN:BSN(Battery Sensor) 0
LIN:FSW(Wiper Motor) 0
LIN:VCS(Rain/Light Sensor) 0
LIN:SHM(Seat Heating/Ventilation) 0
SW-SW-R(Right Headlamp) 0
SW-SW-L(Left Headlamp) 1
MFK(Multifunction Camera) 5
AHE(Trailer Recognition) 0
DTC (116)
ECM(Engine Control Unit) ( 5 DTCs )
DTC Description Status
P007312 The outside temperature sensor has a short circuit to positive. Stored
There is a short circuit to positive.
P007211 The outside temperature sensor has a short circuit to ground. Active and stored
There is a short circuit to ground.
P008A84 The pressure in the fuel low pressure circuit is too low. There is Stored
a signal below the permissible limit value.
The fuel pressure in the system during the starting procedure is Stored
P00C600
too low.
U11A6FC Communication with 'Radar sensor' has a fault. Active and stored(Event codes)
U1444FD Implausible data were received from 'Radar sensorics'. Stored(Event codes)
U105CFF Communication with 'COLLISION PREVENTION ASSIST' has a Active and stored(Event codes)
malfunction.
U151AFE Communication with 'DISTRONIC' or 'Intelligent drive' faulty Active and stored
U151A00 Communication with 'DISTRONIC' or 'Intelligent drive' faulty Active and stored(Event codes)
B000113 The squib for the driver airbag (stage 1) has a malfunction. Stored
There is an open circuit.
B000413 The squib for the driver kneebag has a malfunction. There is an Active and stored
open circuit.
B007913 The squib for the emergency tensioning retractor 'Belt end Active and stored
fitting' (driver) has a malfunction. There is an open circuit.
B007E13 The squib for emergency tensioning retractor 'Driver' has a Active and stored
malfunction. There is an open circuit.
B008013 The squib for belt force limiter 'Driver' has a malfunction. There Active and stored
is an open circuit.
B009015 Left front crash sensor fault - open circuit or short circuit to Active and stored
positive
B00E39A Left rear emergency tensioning retractor squib fault - operating Stored
conditions for component or system not met
The squib for the sidebag 'Driver' has a malfunction. There is an Stored
B275013 open circuit.
B210A84 The power supply in the system is too low. There is a signal Stored(Event codes)
below the permissible limit value.
U111B87 Communication with 'Intelligent drive' faulty - message missing Active and stored(Event codes)
B125895 Center right front distance sensor fault - mechanical setup not Stored
OK
B1FBF13 The 360° camera at the front end has a fault. There is an open Active and stored
circuit
U015586 Communication with the instrument cluster has a malfunction. Active and stored(Event codes)
There is an incorrect signal.
P007011 The outside temperature sensor has an electrical fault. There is Active and stored
a short circuit to ground.
P007015 The outside temperature sensor has an electrical fault. There is Active and stored
a short circuit to positive or an open circuit.
P007084 The outside temperature sensor has an electrical fault. There is Stored
a signal below the permissible limit value.
P007085 The outside temperature sensor has an electrical fault. There is Stored
a signal above the permissible limit value.
B181E64 The sensor for the engine hood has a malfunction. There is an Active and stored
implausible signal.
B22A31C 'Overhead control panel' has a malfunction. The voltage value is Stored
outside the permissible range.
U118A08 Communication failure with 'Left headlamp range adjustment' - Active and stored
signal fault or message error
Communication failure with 'Right headlamp range adjustment' Active and stored
U118B08
- signal fault or message error
B210A00 The power supply in the system is too low. Stored(Event codes)
U012264 Communication with 'Traction system' has a malfunction. Active and stored(Event codes)
There is an implausible signal.
U012287 Communication with 'Traction system' has a malfunction. The Active and stored(Event codes)
message is missing.
U100814 LIN bus 1 has a fault. There is a short circuit to ground or an Stored
open circuit.
U104388 Communication with the peripheral CAN bus has a malfunction. Active and stored
Bus OFF
U119887 Communication with the intelligent servo module (ISM) has a Stored(Event codes)
malfunction. The message is missing.
U301700 The real-time internal control unit clock has a malfunction. Stored
B210D16 The power supply is too low. The limit value for electrical Stored(Event codes)
voltage has not been attained.
U042900 Implausible data were received from the steering column Stored(Event codes)
module.
B210A00 The power supply in the system is too low. Stored(Event codes)
P053300 The refrigerant pressure sensor has a short circuit to positive. Stored
U11A600 Communication with 'Radar sensor' has a fault. Active and stored
B19BE87 Multimedia connection unit 1 has a malfunction. The message Stored(Event codes)
is missing.
B210A00 The power supply in the system is too low. Stored(Event codes)
B227B00 The specified and actual configurations of the MOST Stored(Event codes)
components are different.
U006488 Communication with the user interface CAN bus has a Stored
malfunction. Bus OFF
U014100 Communication with the front signal acquisition and actuation Active and stored(Event codes)
module has a malfunction.
B210D84 The power supply is too low. There is a signal below the Stored(Event codes)
permissible limit value.
B210C16 The power supply is outside the valid range. The limit value for Stored(Event codes)
electrical voltage has not been attained.
B210C16 The power supply is outside the valid range. The limit value for Stored(Event codes)
electrical voltage has not been attained.
B210A00 The power supply in the system is too low. The limit value for Stored(Event codes)
electrical voltage has not been attained.
The power supply is too low. The limit value for electrical
B210D00 voltage has not been attained. Stored(Event codes)
U001988 Communication with the telematics CAN bus has a Active and stored
malfunction. Bus OFF
B210A00 The power supply in the system is too low. Stored(Event codes)
U001988 Interior CAN communication has a malfunction. Bus OFF Stored(Event codes)
U016887 Communication with the electronic ignition lock has a Stored(Event codes)
malfunction. The message is missing.
U016987 Communication with the overhead control panel has a Stored(Event codes)
malfunction. The message is missing.
B210A00 The power supply in the system is too low. Stored(Event codes)
U042329 Implausible data were received from the instrument cluster. Active and stored(Event codes)
There is an invalid signal.
U120B87 Communication with the 'Headlamp' has a malfunction. The Stored(Event codes)
message is missing.
B210A00 The power supply in the system is too low. Stored(Event codes)
U042729 Implausible data were received from the electronic ignition Stored(Event codes)
lock. There is an invalid signal.
U042329 Implausible data were received from the instrument cluster. Stored(Event codes)
There is an invalid signal.
U015587 Communication with the instrument cluster has a malfunction. Stored(Event codes)
The message is missing.
B210A00 The power supply in the system is too low. Stored(Event codes)
P008A84 The pressure in the fuel low pressure circuit is too low. There is Stored
a signal below the permissible limit value.
B210A00 The power supply in the system is too low. Stored(Event codes)
Technician Notes
Customer Name:
Technician:
Date:
Disclaimer: This report provides a reference for vehicle inspection and maintenance only. Autel is not liable for any accident, property damage, or personal
injury resulting from the use of this information.