√𝑨𝒓𝒍𝒐 REVIEW CENTER

CE 508: INTEGRATION COURSE 3 Situation E. A propped beam having a span of 6m carries a uniformly
distributed load of 600kN/m over a length of 2m from the restrained end.
(Structural Theory & Steel Design)
11. Which of the following most nearly gives the moment at the fixed end.
Α. -780 B. -890 C. -620 D. -830
Name: ___________________________________________________

Situation F.
Instruction:
12. What tension must be applied at the ends of a flexible wire cable
1. No copying of answers.
supporting a load of 0.5kg per horizontal meter in a span of 100m if the
2. Incomplete, wrong, or no solution will invalidate your answers.
sag is to be limited to 1.25m
3. Encircle your final answers.
A. 423.42 B. 584.23 C. 500.62 D. 623.24
Situation A. A building frame shown is subjected to wind loading.
Situation G.
13. The allowable spacing of towers to carry an aluminum cable weighing
0.03kg per horizontal meter if the maximum tension at the lowest point
is not to exceed 1150kg at sag of 0.50 m is
A. 248 B. 390 C. 408 D. 422

Situation H. A water supply pipeline crossing a wide river is to be

supported by a 'flexible wire cable with an allowable tensile load of
20,000kg. The pipe weighs 50kg/m and has a total length of 60 m.

14. Which of the following most nearly gives the minimum sag
A. 1.65 B. 1.13 C. 2.35 D. 0.54
15. Which of the following most nearly gives the tension at the lowest
point of the cable?
A. 19900 B. 15400 C. 11100 D. 14300
1. Which of the following most nearly gives the vertical component of the
16. If the sag is to be 2 m, which of the following most nearly gives the
reaction at A.
tension at the support.
A. 110 B. 130 C. 140 D. 120
A. 15650 B. 12100 C. 11350 D. 18150
2. Which of the following most nearly gives the horizontal component of
the reaction at A.
Situation I. A steel column hinged at both ends has the following
A. 285 B. 255 C. 295 D. 305
properties: Modulus of elasticity of 200,000 MPa, yield strength of 200
3. Which of the following most nearly gives the total reaction at B.
MPa, length of 12 m, moment of Inertia of 37.7x106 mm4 and area of
A. 324.3 B. 287.3 C. 309.2 D. 254.7
8000 mm².

Situation B. For the restrained beam shown below 17. The allowable stress is
A. 33.92 B. 31.92 C. 30.92 D. 32.92

Situation J. A built-up column of A36 steel consist of W14 x 311 core

section with two 450mm x 25mm cover plates as shown. Effective length
factor is 1 and the unbraced length is 6 m. Use Fy=248MPa.

4. Which of the following gives the total load on the beam.

A. 27 B. 36 C. 14 D. 21
5. Which of the following gives the moment at A.
A. 25.12 B. 36.21 C. 34.69 D. 42.45
6. Which of the following gives the moment at B.
A. 27.32 B. 20.06 C. 14.52 D. 12.22

Situation C. A continuous beam has two spans, the left span being 4m
long, and the right span is 6m long. The beam is restrained at the
leftmost support, hinged at the interior support, and roller at the rightmost
support. The beam caries a concentrated load of 40kN at the middle of
the 4m span and a uniform load of 5kN/m throughout the 6m span.

7. Determine the moment at the restrained end.

A. 18.33 B. 20.67 C. 17.67 D. 19.17
8. Determine the moment at the interior support.
A. 21.67 B. 26.67 C. 19.67 D. 20.33 18. Which of the following gives the moment of inertia of the built-up
9. Determine the vertical reaction at the interior support. section with respect to the Y-axis in m4.
A. 42.5 B. 35.2 C. 29.2 D. 28.6 A. 0.00176 Β. 0.00213 C. 0.00105 D. 0.00087
19. Which of the following gives the maximum effective slenderness ratio
Situation D. A fixed-ended beam 4m long carries a uniformly distributed of the column in millimeters.
load of 2kN/m over the middle 2m. Α. 45.65 B. 52.86 C. 78.21 D. 67.87
20. Which of the following gives the safe axial load that the column can
10. Which of the following most nearly gives the end moment. resist in Kilonewton.
A. -1256 B. -4563 C. -1830 D. 2560 A. 12,560 B. 13,290 C. 15,713.29 D. 14,760