Scribd
Upload
38 views

Technical Drawing 3, WASSCE (SC), 2017

The document discusses the performance of candidates in Technical Drawing for WASSCE 2023, specifically regarding Question 2, which required a freehand sketch of a rammer. It highlights that many candidates lacked knowledge of the tool and failed to meet proportionality standards in their sketches. The document outlines the major requirements for the sketching task, including resemblance, neatness, and specific faces of the base and handle.

Uploaded by

michaelorji0008
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
38 views

Technical Drawing 3, WASSCE (SC), 2017

The document discusses the performance of candidates in Technical Drawing for WASSCE 2023, specifically regarding Question 2, which required a freehand sketch of a rammer. It highlights that many candidates lacked knowledge of the tool and failed to meet proportionality standards in their sketches. The document outlines the major requirements for the sketching task, including resemblance, neatness, and specific faces of the base and handle.

Uploaded by

michaelorji0008
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Technical Drawing 3, WASSCE (SC), 2023

Subject Home 1 2 3 4 5

Menu Question 2
General Comments
(2) Make a freehand sketch of the pictorial view of a rammer.
Weakness/Remedies

Candidate's Strength
Observation
Most candidates showed to have not known what rammer is. Not only did they not know what exactly the
specified tool is, the sketches they presented did not portray proportionality requirement.

The expected response from the candidates is given below.

MAJOR WORK REQUIRED IN THE SKETCHING


1. Sketching the pictorial view
2. Resemblance
3. Proportionality
4. Sketching faceA of the base
5. Sketching face B of the base
6. Sketching face C of the base
7. Sketching the handle
8. Neatness and quality of lines

Prev Next

Copyright © 2018. The West African Examinations Council. All rights reserved.
Powered by Sidmach Technologies (Nigeria) Limited.

You might also like