SP6853

Green-Mode PWM Controller

DESCRIPTION APPLICATIONS
The SP6853 is a low cost , low startup current , z AC/DC Switching Power Adaptor
current mode PWM controller with green-mode z Battery Charger
power-saving operation. The integrated functions z PC 5V Standby Power.
include the leading-edge blanking of the current z Open-Frame Switching Power Supply
sensing, internal slope compensation. It would
provide the users a superior AC/DC power
application of higher efficiency, low external
component counts, and lower cost solution for
applications.
The SP6853 features more protections or functions
for the following characteristics :
※Add OLP (Over Load Protection) function to
provide better protection performance for fault
conditions like short circuit or over load.
※Modify the OVP (Over Voltage Protection)
mechanism from the cycle-by-cycle mode to the
hiccup mode.
SP6853 is available by SOT-23-6L / DIP-8P
packages.

FEATURES PIN CONFIGURATION

z High-Voltage BiCMOS Process SOT-23-6L DIP-8P
z Very Low Startup Current (<20µA)
z Under Voltage Lockout (UVLO )
z Current Mode Control
z Non-audible-noise Green Mode Control
z Current Limiting
z LEB (Leading-Edge Blanking) on CS Pin
z OLP (Over Load Protection)
z OVP (Over Voltage Protection) on Vcc Pin
z Leading-Edge Blanking
z Programmable Switching Frequency
z Internal Slope Compensation
z Green-Mode Control for Power Saving
z 300mA Driving Capability
z
PART MARKING
SOT-23-6L DIP-8P

2008/08/10 Ver.1 Page 1

 SP6853
Green-Mode PWM Controller
TYPICAL APPLCATION CIRCUIT

TYPICAL APPLCATION CIRCUIT ( High Efficiency SMPS + Synchronous Rectifier )

2008/08/10 Ver.1 Page 2

 SP6853
Green-Mode PWM Controller
PIN DESCRIPTION
SP6853D8TG
Pin Symbol Description
1 OUT Gate driver output to drive the external MOSFET
2 VCC Supply Voltage in
3 NC Unconnected pin
Current sense. This pin senses the voltage across a resistor, to control PWM output. This pin
4 CS
also provides current amplitude information for current-mode control.
5 RT This current is used to charge an internal capacitor, to determine the switching frequency.
6 NC Unconnected pin
Voltage feedback. The pin provides the output voltage regulation signal., it provides feedback
7 COMP
to the internal PWM comparator, so that the PWM comparator can control the duty cycle.
8 GND Ground
SP6853S26RG
Pin Symbol Description
1 GND Ground
Voltage feedback. The pin provides the output voltage regulation signal., it provides feedback
2 COMP
to the internal PWM comparator, so that the PWM comparator can control the duty cycle
3 RT This current is used to charge an internal capacitor, to determine the switching frequency.
Current sense. This pin senses the voltage across a resistor, to control PWM output. This pin
4 CS
also provides current amplitude information for current-mode control
5 VCC Supply Voltage in
6 OUT Gate driver output to drive the external MOSFET

BLOCK DIAGRAM

2008/08/10 Ver.1 Page 3

 SP6853
Green-Mode PWM Controller
ORDERING INFORMATION
Part Number Package Part Marking
SP6853D8TGB DIP-8P SP6853I
SP6853S26RGB SOT-23-6L 853YW
※ SP6853D8TG : Tube ; Pb – Free ; Halogen-Free
※ SP6853S26RG : Tape Reel ; Pb – Free ; Halogen-Free

ABSOULTE MAXIMUM RATINGS (TA=25℃, unless otherwise specified.)

The following ratings designate persistent limits beyond which damage to the device may occur.
Symbol Parameter Value Unit
VCC DC Supply Voltage 36 V
VCOMP / RT / CS COMP / RT / CS Voltage -0.3 ~ 7.0 V
PD Power Dissipation @ TA=85℃ (*) 0.3 W
Human Body Model 4 KV
ESD
Machine Model 300 V
Tope Operating Ambient Temperature -40 ~ 85 ℃
TJ Operating Junction Temperature Range -40 ~ 150 ℃
TSTG Storage Temperature Range -40 ~ 150 ℃
TLEAD Pb-Free Lead Soldering Temperature for 5 sec. 260 ℃
SOT-23-6L 210
RӨJC Thermal Resistance Junction – Case (*) ℃/W
DIP-8P 95
(*) The power dissipation and thermal resistance are evaluated under copper board mounted with free air conditions.

2008/08/10 Ver.1 Page 4

 SP6853
Green-Mode PWM Controller
ELECTRICAL CHARACTERISTICS
(TA=25℃, VCC=15V, unless otherwise specified.)

Symbol Parameter Conditions Min. Typ. Max. Unit

Supply Voltage ( Vcc Pin )
Istt Startup Current 10 20 uA
VCOMP = 0V 2.7 4 mA
Iop Operating Current VCOMP = 3V 2.4 mA
Protection tripped
(OLP, OVP)
1.0 mA
UVLO (off) Min. Operating Voltage 9.0 10.0 11.0 V
UVLO (on ) Start Threshold Voltage 15.0 16.0 17.0 V
OVP Level Over Voltage Protection 24 26 29.5 V
Voltage Feedback ( Comp Pin )
Isc Short Circuit Current 1.25 2.2 mA
Vop Open Loop Voltage 6 V
VTH(GM) Green Mode Threshold VCOMP 2.35 V
Oscillator ( RT Pin )
FOSC Frequency RT=100KΩ 60.0 68.0 75.0 KHz
FOSC(GM) Green Mode Frequency Fs=65.0KHz 22 KHz
Fdt Frequency Variation versus Temp. Deviation (-40°C ~105°C) 3 %
Fdv Frequency Variation versus VCC Deviation (VCC=11V-25V) 1 %
Current Sensing ( CS Pin )
Vcs(off) Maximum Input Voltage 0.8 0.85 0.9 V
TLEDD Leading Edge Blanking Time 280 nS
Zcs Input impedance 1 MΩ
TPD Delay to Output 100 nS
Gate Driver Output ( OUT Pin )
DC (Max) Maximum Duty Cycle 70 75 80 %
DC (Min) Minimum Duty Cycle 0 %
VCC=15V,
VOL Output Low Level Io=20mA
1 V
VCC=15V,
VOH Output High Level 8 V
Io=20mA
Tr Rising Time Load Cap=1000pF 50 200 nS
Tf Falling Time Load Cap=1000pF 30 120 nS
OLP ( Over Load Protection )
TLOLP OLP Trip Level 5.0 V
TDOLP OLP Delay Time (note) 60 mS
Note: The OLP delay time is proportional to the period of switching cycle. So that, the lower RT value will set the higher
switching frequency and the shorter OLP delay time.

2008/08/10 Ver.1 Page 5

 SP6853
Green-Mode PWM Controller
PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.)

2008/08/10 Ver.1 Page 6

 SP6853
Green-Mode PWM Controller
PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.)

2008/08/10 Ver.1 Page 7

 SP6853
Green-Mode PWM Controller
PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.)

Max Duty Cycle

Min Duty Cycle

Max Duty Cycle

Min Duty Cycle

Max Duty Cycle Min Duty Cycle

2008/08/10 Ver.1 Page 8

 SP6853
Green-Mode PWM Controller
PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.)

Rising Time Load Falling Time Load

Rising Time Load Falling Time Load

Rising Time Load Falling Time Load

2008/08/10 Ver.1 Page 9

 SP6853
Green-Mode PWM Controller
PERFORMANCE CHARACTERISTICS (TA=25℃, unless otherwise specified.)

Leading Edge Blanking Time OLP Delay Time

Leading Edge Blanking Time

OLP Delay Time

Leading Edge Blanking Time OLP Delay Time

2008/08/10 Ver.1 Page 10

 SP6853
Green-Mode PWM Controller
DIP- 8P PACKAGE OUTLINE

2008/08/10 Ver.1 Page 11

 SP6853
Green-Mode PWM Controller
SOT-23-6L PACKAGE OUTLINE

2008/08/10 Ver.1 Page 12