8 7 6 5 4 3 2 1

REVISIONS

NOTES: REV. DESCRIPTION DATE APPROVED

1. WIRE PER TABLE 1 BELOW. WORKMANSHIP TO BE IAW IPC/WHMA-A-620. A INITIAL RELEASE 2/15/2024 JL

F
2. ITEM 2, CABLE, MUST HAVE AN OD BETWEEN 3.5-5.0 mm (0.138-0.197") TO BE COMPATIBLE WITH ITEM 1. F

3. ITEM 4 TO BE LOCATED NO MORE THAN 0.5m FROM ITEM 1 CONNECTOR AND COVERED WITH ITEM 5.
ITEM 4 TO CONTAIN THE FOLLOWING INFORMATION:
1. PART NUMBER (HA-CBL-IM-ETH-02)
2. DATE CODE YYWW FORMAT (EX: 1535)

4. CUT ITEM 3, M12 CABLE, IN HALF AND USE ONE END PER ASSEMBLY.

5. ASSEMBLE ALL SOCKETS PER MANUFACTURERS RECOMMENDATIONS.

6. TEST ALL PINS FOR CONTINUITY AND SHORT TO OTHER PINS. E

E

7. CABLE LENGTH IS MEASURED FROM FACE OF ITEM 1 TO FACE OF ITEM 3, AS SHOWN.

8. COVER SOLDER CONNECTION BETWEENS ITEMS 2 AND 3 WITH ITEM 6, HEAT SHRINK.

TABLE 1: CABLE WIRING

CONNECT FROM CONNECT USING CONNECT TO SIGNAL
D ITEM 1, PIN 1 ITEM 2 (TWISTED PAIR 1) ITEM 3, PIN 1 Tx+ D
ITEM 1, PIN 2 ITEM 2 (TWISTED PAIR 1) ITEM 3, PIN 2 Tx-
ITEM 1, PIN 3 ITEM 2 (TWISTED PAIR 2) ITEM 3, PIN 3 Rx+
ITEM 1, PIN4 ITEM 2 (TWISTED PAIR 2) ITEM 3, PIN 4 Rx-

1 2 5 3 4 8 3

PIN 2 PIN 4 PIN 1 PIN 8

C

PIN 7
C
PIN 2

ALIGNMENT KEY
+0.2
3.0 m 0.0 PIN 3 PIN 6

PIN 1 PIN 3 7 PIN 4 PIN 5

A
ITEM 1 ITEM 3

B
ITEM NO. PART NUMBER QTY. DESCRIPTION SOURCE MFG MFG P/N MFG 2 MFG P/N 2 B

1 2003521 1 CONNECTOR, PLUG, MALE PINS, 4 POS., M8 AS SPECIFIED TE CONNECTIVITY T4011019041-000

2 2003573 3m CABLE, 4 CONDUCTOR (2 TWISTED PAIRS), 22 AWG, 100' LONG, OPEN ALPHA WIRE 2466L SL005 DIGIKEY 2466LSL005-ND
0.161" (4.09mm) OD
3 2003575 0.5 CABLE, PLUG, MALE PINS, 8 POS., M12, X-CODED, 1.5m LONG AS SPECIFIED TE CONNECTIVITY 10-03986 DIGIKEY 839-10-03986-ND

4 2002094 1 LABEL, 1.0" X 0.5" METALLIZED POLYESTER OPEN BRADY THT-5-428-10

5 2003528 A/R HEAT SHRINK TUBING, CLEAR, .25" ID BEFORE, .13" ID AFTER OPEN McMASTER 7496K46

6 2003070 A/R MOISTURE SEAL HEAT SHRINK TUBING, 0.31" ID, 3:1 RATIO OPEN McMASTER 7861K611

STRATA SAFETY PRODUCTS, LLC

NAME DATE
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS DRAWN JL 2/15/24
TOLERANCES: 130 TECHNOLOGY DRIVE
ANGULAR: MACH .01
NO PLACE DECIMAL 1 CHECKED CANONSBURG, PENNSYLVANIA 15317 A
ONE PLACE DECIMAL .2
A TWO PLACE DECIMAL .1 ENG APPR. TITLE:

IM ETHERNET CABLE, M8 TO M12,

MFG APPR.
MATERIAL

3m LG.
Q.A.
FINISH
PROPRIETARY AND TRADE PATENTS:
STANDARD NOTES:
SECRET INFORMATION USA(8,232,888; 8,552,882; A. INTERPET THIS DRAWING IAW SIZE DWG. NO. REV

D
8,446,277; 8,169,335; 7,420,471;

A
6,810,353; 8,710,979; 8,810,390;
ASME Y14.100
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
STRATA SAFETY PRODUCTS, LLC. ANY
8,847,780)
RSA(2007/2919; 2008/2673;
2010/6816; 2010/9068; 2011/07178)
B. DIMENSION AND TOLERANCE
PER ASME Y14.5
HA-CBL-IM-ETH-02
REPRODUCTION IN PART OR AS A WHOLE AU (2005289704; 2008316786)
WITHOUT WRITTEN PERMISSION IS MX (312439) C. THIS DRAWING IS CAD GENERATED
PROHIBITED. PATENTS PENDING: NO MANUAL CHANGES AUTHORIZED SCALE: 2:1 WEIGHT: SHEET 1 OF 1
USA;ZA;AU;CA;EP;MX

8 7 6 5 4 3 2 1