0% found this document useful (0 votes)
388 views

LM390 Simple 2-Way Intercom Circuit

This document summarizes a simple two-way intercom circuit using an LM390 audio amplifier. The circuit allows for limited two-way communication between two stations each with an 8 ohm speaker, powered by a 6 volt DC supply. Gain can be adjusted through a resistor or FET connected from pin 6 to ground. The LM390 amplifier is optimized for 6-9V operation into low impedance loads, with an internal gain of 20, but external components can increase the gain up to 200.

Uploaded by

Hossam Zizo
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
388 views

LM390 Simple 2-Way Intercom Circuit

This document summarizes a simple two-way intercom circuit using an LM390 audio amplifier. The circuit allows for limited two-way communication between two stations each with an 8 ohm speaker, powered by a 6 volt DC supply. Gain can be adjusted through a resistor or FET connected from pin 6 to ground. The LM390 amplifier is optimized for 6-9V operation into low impedance loads, with an internal gain of 20, but external components can increase the gain up to 200.

Uploaded by

Hossam Zizo
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

LM390 Simple 2-Way intercom Circuit

This is a very simple two way intercom circuit based on a LM390 audio amplifier circuit. The intercom circuit is a stand-alone electronic communications system intended for limited or private dialogue. For this circuit you can use a 8 ohms speaker, one for each station and require a 6 volts dc power supply. Gain control can be done by capacitive coupling a resistor (or FET) from pin 6 to ground.

LM390 Pin out

The LM390 Power Audio Amplifier is optimized for 6V, 7.5V, 9V operation into low impedance loads. The gain is internally set at 20 to keep the external part count low, but the addition of an external resistor and capacitor between pins 2 and 6 will increase the gain to any value up to 200. The inputs are ground referenced while the output is automatically biased to one half the supply voltages.

You might also like