Scribd
Upload
9 views

DIR-600_How_to_factory_reset

This document provides instructions on how to factory reset the DIR-600 wireless router. To reset, locate the reset pinhole, use a paperclip to hold the button for 10 seconds until the Power LED changes color, then wait for the reset process to complete. It also advises ensuring the router has the latest firmware version after the reset.

Uploaded by

negx61
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views

DIR-600_How_to_factory_reset

This document provides instructions on how to factory reset the DIR-600 wireless router. To reset, locate the reset pinhole, use a paperclip to hold the button for 10 seconds until the Power LED changes color, then wait for the reset process to complete. It also advises ensuring the router has the latest firmware version after the reset.

Uploaded by

negx61
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Wireless N

How to factory reset

This document will detail how to reset back to a default configuration the DIR-600.

If passwords have been forgotten and or configurations have been done incorrectly or
access to the DIR-600 is limited, resetting back to the default configuration can assist.

D-Link Technical Support – How to factory reset the DIR-600. Page 1 of 2


1. Locate the reset pin hole on the back of the DIR-600 as per below:

2. Insert a paperclip into the reset pin hole and hold in for 10 seconds. While holding in
the reset button, refer to the Power LED, when it turns yellow/orange, release the
paperclip holding in the reset button.

NOTE: This is a 10 second countdown process for the Power LED to change colour.

3. Below is an picture of the Power LED on the DIR-600.

4. Wait for 30-60 seconds for the process to complete, once the Power LED is back to a
green colour and usually if an Ethernet connected computer is connected either Ports 1, 2,
3 or 4 will be illuminated again to advise the reset process has been completed.

5. Factory reset is now complete.

IMPORTANT:

Please remember to ensure your DIR-600 has the most current firmware version
applied. To apply this firmware please refer to the Technical Support Knowledge
Base.

D-Link Technical Support – How to factory reset the DIR-600. Page 2 of 2

You might also like