Scribd
Upload
15 views3 pages

Rf Detail Slab_removed

The document outlines the design considerations for reinforced concrete slabs, including checks for cracking and shear strength. It specifies calculations for bar diameters, anchorage lengths, and reinforcement details for one-way and two-way slabs. The checks indicate compliance with structural requirements, confirming that the design is satisfactory.

Uploaded by

Raunak Dembra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
15 views3 pages

Rf Detail Slab_removed

The document outlines the design considerations for reinforced concrete slabs, including checks for cracking and shear strength. It specifies calculations for bar diameters, anchorage lengths, and reinforcement details for one-way and two-way slabs. The checks indicate compliance with structural requirements, confirming that the design is satisfactory.

Uploaded by

Raunak Dembra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

At simple support, where compressive reaction confines the bars, to limit the dia.

of bar

Since alternate bars are cranked M1=Mu/2 = 23.2/2 = 11.8 kN.m


V1 = 5.93 kN., Providing 90o bend and 25 mm end cover
Lo = 230/2 – 25 + 3(dia of bar) = 120
470 < (1.3x11.8x106) / (25.9x103) + 120 = 711 mm O. K.
However, from the end anchorage requirement
extend the bars for a length equal to ld/3 = 156 mm from inner face of support

8) Check for cracking


• Steel is more than 0.12% of the gross area.
• Spacing of steel is < 3d
• Diameter of bar used is < 160/8=20mm
Check for cracking is satisfied.

Reinforcement Detail of One way slab


Reinforcement Detail of Two way Restrained slab
N/mm2
For solid slab shear strength = k.
k = 1.3 (for thickness 150 mm & less )
=1.3 x 0.4 =0.52 N/mm2 > 0.22 N/mm2 (OK)

7) Check for cracking


Since steel is more than 0.12% of the gross area,
Spacing of steel is <3d and
Diameter of bar used is 8 and 10 mm and are < D/8=150/8=19 mm
(OK)

Reinforcement Detail of One way Continuous slab

You might also like