Scribd
Upload
17 views4 pages

int led1

This document contains an Arduino sketch that controls eight LEDs based on serial input. Each LED can be turned on or off by sending specific characters ('A' to 'P') through the serial interface. The setup function initializes the LED pins as outputs and begins serial communication at 9600 baud rate.

Uploaded by

hngocvuong03
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
17 views4 pages

int led1

This document contains an Arduino sketch that controls eight LEDs based on serial input. Each LED can be turned on or off by sending specific characters ('A' to 'P') through the serial interface. The setup function initializes the LED pins as outputs and begins serial communication at 9600 baud rate.

Uploaded by

hngocvuong03
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

int led1 = 2;

int led2 = 3;

int led3 = 4;

int led4 = 5;

int led5 = 6;

int led6 = 7;

int led7 = 8;

int led8 = 9;

int val;

void setup()

pinMode(led1,OUTPUT);

pinMode(led2,OUTPUT);

pinMode(led3,OUTPUT);

pinMode(led4,OUTPUT);

pinMode(led5,OUTPUT);

pinMode(led6,OUTPUT);

pinMode(led7,OUTPUT);

pinMode(led8,OUTPUT);

Serial.begin(9600);

void loop()

while(Serial.available())

val = Serial.read();

if (val == 'A')

digitalWrite(led1,LOW);
}

else if (val == 'B')

digitalWrite(led1,HIGH);

if (val == 'C')

digitalWrite(led2,LOW);

else if (val == 'D')

digitalWrite(led2,HIGH);

if (val == 'E')

digitalWrite(led3,LOW);

else if (val == 'F')

digitalWrite(led3,HIGH);

if (val == 'G')

digitalWrite(led4,LOW);

else if (val == 'H')

digitalWrite(led4,HIGH);

}
if (val == 'I')

digitalWrite(led5,LOW);

else if (val == 'J')

digitalWrite(led5,HIGH);

if (val == 'K')

digitalWrite(led6,LOW);

else if (val == 'L')

digitalWrite(led6,HIGH);

if (val == 'M')

digitalWrite(led7,LOW);

else if (val == 'N')

digitalWrite(led7,HIGH);

if (val == 'O')

digitalWrite(led8,LOW);

else if (val == 'P')


{

digitalWrite(led8,HIGH);

}}

You might also like