Scribd
Upload
5 views

BE Question Paper

The document is a question paper for the B.Tech IInd Semester Sessional Examination in Basic Electronics at Manipal Academy of Higher Education, dated March 2024. It includes multiple-choice questions and descriptive problems covering topics such as hexadecimal conversion, MOSFET operation, OP-AMP circuits, and diode characteristics. The paper consists of 30 marks with a duration of 120 minutes.

Uploaded by

khushpatel1222
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
5 views

BE Question Paper

The document is a question paper for the B.Tech IInd Semester Sessional Examination in Basic Electronics at Manipal Academy of Higher Education, dated March 2024. It includes multiple-choice questions and descriptive problems covering topics such as hexadecimal conversion, MOSFET operation, OP-AMP circuits, and diode characteristics. The paper consists of 30 marks with a duration of 120 minutes.

Uploaded by

khushpatel1222
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

4/9/24, 11:37 AM Question Paper - Report :: Exampad

09-Apr-2024 11:34:17
Question Paper - KHUSH KEYUSH PATEL .

Report Logout

Question Paper Back

MANIPAL ACADEMY OF HIGHER EDUCATION


B.Tech IInd Semester Sessional Examination March 2024
BASIC ELECTRONICS [ECE 1071-PHY]
Marks: 30 Duration: 120 mins.
MCQ
Answer all the questions. Section Duration: 20 mins
1) Find hexadecimal equivalent of (40.16)8
(0.5)
(80.38)16 (20.38)16 (20.16)16 (80.16)16
2) Convert (97.75)10 to its equivalent binary number

(0.5)
(1100001.110)2 (1000011.110)2 (1000011.011)2 (1100001.011)2

3) Two’s Complement of (1011.1010)2 is

(0.5)
(1011.1011)2 (0100.0101)2 (0100.0110)2 (0101.0101)2

4) The output voltage V0 of OP-AMP is ______. (0.5)

https://manipal.examcloud.in/reports/viewqpaper.php?ev=MTk3Mw%3D%3D&ex=NTY1OTU%3D&aid=MjA2OTMwOA%3D%3D 1/5
4/9/24, 11:37 AM Question Paper - Report :: Exampad

2.5 V -2.5 V 12 V -12 V

5) Which of the following statement is true.

MOSFET Drain MOSFET Drain Drain current is MOSFET is in


current increases current unaffected by saturation (0.5)
with the increase decreases with change in drain to region, if VDS
in gate to source the increase in source voltage in is less than VGS
voltage. (W/L) value. triode region. - VTH.

6) The MOSFET shown in the circuit below is operated in ------------- region. Assume
VTH = 0.5V

(0.5)

Saturation Cut-off Triode


7) For the circuit shown, the output voltage VO is ------------, if the input voltage VIN
is 1V DC. Assume supply voltage to OP-AMP as ±10V.

(0.5)

100V -100V -10V -1V

8) If the input to an OP-AMP integrator is square wave, the output of OP-AMP is -----
----.
(0.5)
Sinusoidal wave. Triangular wave. Spikes. None of these.

9) For the circuit shown, the output voltage is ----------. Assume diodes ‘D1’, ‘D2’ as (0.5)
ideal.

https://manipal.examcloud.in/reports/viewqpaper.php?ev=MTk3Mw%3D%3D&ex=NTY1OTU%3D&aid=MjA2OTMwOA%3D%3D 2/5
4/9/24, 11:37 AM Question Paper - Report :: Exampad

3V 2V 1V 5V

10) Which of the following statement is incorrect?

In a bridge The output signal Diode in half The regulated


rectifier circuit, frequency of a full wave rectifier output voltage
two diodes wave rectifier with capacitor of Zener (0.5)
conduct at a circuit is 50Hz, if filter conducts for regulator is
time for the applied input less than half Zener
sinusoidal signal frequency is cycle for breakdown
input. 100Hz. sinusoidal input. voltage.

DESCRIPTIVE
Answer all the questions.
11) Consider a bridge rectifier connected to a primary supply of 220V RMS, 50Hz. If
the turns ratio of the transformer is 10:1, calculate the

i. Average and RMS value of load current through 1KΩ load.

ii. Efficiency and ripple factor of the circuit. (4)

Also, draw the circuit and sketch the input (across secondary terminal) and output
waveforms indicating the peak voltage and the frequency.

12) Obtain an expression for drain current of MOSFET in terms of gate voltage, drain
voltage and aspect ratio. Also, sketch the VDS – ID Characteristics of MOSFET
indicating various regions of operation. (4)

13) A Silicon diode has a saturation current of 1pA at 300C under a forward bias
voltage of 0.8V. Determine the

(i) Diode current when the temperature changes to 800C. (3)

(ii) Dynamic resistance at 800C.

14) Consider a Zener regulator with following specifications: (3)

https://manipal.examcloud.in/reports/viewqpaper.php?ev=MTk3Mw%3D%3D&ex=NTY1OTU%3D&aid=MjA2OTMwOA%3D%3D 3/5
4/9/24, 11:37 AM Question Paper - Report :: Exampad

Load voltage =10V, input voltage = (20±5) V, Load current=50 mA, IZMIN = 5 mA,
PZ = 1W.

Find the minimum and maximum value of series resistance ‘R’.

15) For the circuit shown in the figure below, check whether the MOSFET is in
saturation. Assume

µnCOX =100µA/V2, VTH =0.5V. Also, calculate the change in the drain voltage, if
the gate voltage

increases by 12mV.

(3)

16) Design a circuit using two operational amplifiers to obtain a output voltage VO =
3V1-5V2+ V3-

2V4., where V1, V2, V3 and V4 are the input voltages. Choose feedback resistance (3)
as 15KΩ.

17) (i) Draw the circuit and obtain an expression for an inverting differentiator using
OP-AMP.

(ii) For the circuit shown below, determine the output voltage of the OP-AMP for
VIN =1V and

R1=R2. Assume OP-AMP is operated in the non-linear region and VCC = 10V.

(3)

18) Briefly explain the working principle of: (i) LED and (ii) Photodiode (2)

https://manipal.examcloud.in/reports/viewqpaper.php?ev=MTk3Mw%3D%3D&ex=NTY1OTU%3D&aid=MjA2OTMwOA%3D%3D 4/5
4/9/24, 11:37 AM Question Paper - Report :: Exampad

© 2024 All rights reserved. epm IP: 45.112.146.138 epCloud 1.5


^ Top

https://manipal.examcloud.in/reports/viewqpaper.php?ev=MTk3Mw%3D%3D&ex=NTY1OTU%3D&aid=MjA2OTMwOA%3D%3D 5/5

You might also like