Scribd
Upload
3 views

MAA QBank

The document is a question bank for a course related to microcontrollers, specifically the 8051 and interfacing with various components. It includes questions on ADC, UART, LCD, DAC, stepper motors, and temperature sensors, along with programming tasks and interfacing diagrams. The questions are categorized into 2-mark and 4-mark sections, covering both theoretical and practical aspects of microcontroller applications.

Uploaded by

noobk1794
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3 views

MAA QBank

The document is a question bank for a course related to microcontrollers, specifically the 8051 and interfacing with various components. It includes questions on ADC, UART, LCD, DAC, stepper motors, and temperature sensors, along with programming tasks and interfacing diagrams. The questions are categorized into 2-mark and 4-mark sections, covering both theoretical and practical aspects of microcontroller applications.

Uploaded by

noobk1794
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MAA Question Bank

2 Marks
1.State the pins on ADC 0808/09 use for hand shaking with microcontroller
8051(2m)
2.Define baud rate in UART.List any 2 standard baud rate (2m)
3.Draw the format of IE and IP SFR(2m)
4.Draw the interfacing diagram of relay connected to P2.1 for 8051
microcontroller (2m)
5.Draw interfacing diagram of 4x4 matrix with 8051 microcontroller (2m)
6.Sketche the format of SCON SFR(2m/4m)
7.Explain the function of following pin of LCD.( RS ,RW ,EN,VEE).(2m)
8.Explain the function of SOC,EOC,ALE and OE pins of ADC 0808/09(2m)
9.Write any 4 command codes with there function (2m)
10.Draw LCD interfacing with 8051.(2m)

4 Marks
1.Stepper motor interfacing and program for Clockwise
2.Stepper motor interfacing and program for anticlockwise
[any 1 from above]
3.Draw interfacing diagram of DAC with 8051 and write a program to
generate continuous square waveform
4.Write a program to generate triangular waveform using DAC
5.Develop an ALP to generate square wave of 2KHz using timer 8051
microcontroller on port pin P1.5 (Assume crystal=12MHz)
[Dac any 1]
6.Develop an ALP to transmit message 'MSBTE' serially at baud rate of 9600
8bit data,1 stop bit.Assume fcrystal of 11.0592
7.Draw the interfacing of ADC with 8051 and also write the program to read
the data from ADC.
8.Develop an ALP to read temperature from LM35 sensor. Draw the
interfacing diagram with 8051
9.Temperature controller using LM35 and ADC with 8051 and program
10. Draw interfacing diagram of 7 segment display with 8051 microcontroller.
Write an ALP count from 0 to 9
11.Write an ALP to rotate stepper motor in clock wise direction through 180
degree consider step angle of motor as 0.9 degree per steps. Write the
sequence used for rotation

You might also like