Scribd
Upload
4 views

DR-6 Installation Manual (EN) 36

The document outlines the process for measuring phase sequence using voltage indicators and a phase sequence indicator. It states that if no voltage is detected, the phase sequence is correct, and measuring voltage between different phases can help verify the measurement. An optional phase sequence indicator model RM086000 is mentioned for this purpose.

Uploaded by

hoomanir1980
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views

DR-6 Installation Manual (EN) 36

The document outlines the process for measuring phase sequence using voltage indicators and a phase sequence indicator. It states that if no voltage is detected, the phase sequence is correct, and measuring voltage between different phases can help verify the measurement. An optional phase sequence indicator model RM086000 is mentioned for this purpose.

Uploaded by

hoomanir1980
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

4.

5 Measuring phases sequence

The phase sequence is usually


measured between K functions.
The phase sequence can be
measured easily using the
voltage indicators (A) on the
front panel,

• Measure using a voltage meter/phase


sequence indicator (B) between the
corresponding phases. A phase
sequence indicator (RM086000) is
optionally available.

If no voltage can be measured,


the phase sequence is correct.
Measuring the voltage between
two different phases allows you
to check the measurement.
Obviously a voltage should be
measured in this case. Figure 32: Measuring phase sequence

4-16 DW646112

You might also like