Scribd
Upload
9 views1 page

MGU-2010

The document outlines the course ME010 801 Design of Transmission Elements, which focuses on the design of various transmission components such as clutches, brakes, bearings, and gears, with a total of 4 credits. It includes four modules covering clutches and brakes, bearing design, gear design, and internal combustion engine parts, along with design recommendations for manufacturing processes. Students are allowed to use specified design data books for reference during the final examination.

Uploaded by

Manoj Tharian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views1 page

MGU-2010

The document outlines the course ME010 801 Design of Transmission Elements, which focuses on the design of various transmission components such as clutches, brakes, bearings, and gears, with a total of 4 credits. It includes four modules covering clutches and brakes, bearing design, gear design, and internal combustion engine parts, along with design recommendations for manufacturing processes. Students are allowed to use specified design data books for reference during the final examination.

Uploaded by

Manoj Tharian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ME010 801 Design of Transmission Elements

(Common with AU010 801)

Teaching scheme Credits: 4

2 hours lecture, 2 hour tutorial and 1 hour drawing per week

Objectives
To provide basic design skill with regard to various transmission elements like clutches, brakes, bearings and
gears.
Module I (20 Hrs)
Clutches - friction clutches- design considerations-multiple disc clutches-cone clutch- centrifugal clutch -
Brakes- Block brake- band brake- band and block brake-internal expanding shoe brake.

Module II (17 Hrs)


Design of bearings - Types - Selection of a bearing type - bearing life - Rolling contact bearings - static
and dynamic load capacity - axial and radial loads - selection of bearings - dynamic equivalent load -
lubrication and lubricants - viscosity - Journal bearings - hydrodynamic theory - design considerations -
heat balance - bearing characteristic number - hydrostatic bearings.
Module III (19 Hrs)
Gears- classification- Gear nomenclature - Tooth profiles - Materials of gears - design of spur, helical,
bevel gears and worm & worm wheel - Law of gearing - virtual or formative number of teeth- gear tooth
failures- Beam strength - Lewis equation- Buckingham’s equation for dynamic load- wear load-
endurance strength of tooth- surface durability- heat dissipation - lubrication of gears - Merits and
demerits of each type of gears.
Module IV (16 Hrs)
Design of Internal Combustion Engine parts- Piston, Cylinder, Connecting rod, Flywheel
Design recommendations for Forgings- castings and welded products- rolled sections- turned parts,
screw machined products- Parts produced on milling machines. Design for manufacturing - preparation
of working drawings - working drawings for manufacture of parts with complete specifications including
manufacturing details.
Note: Any one of the following data book is permitted for reference in the final University examination:

1. Machine Design Data hand book by K. Lingaiah, Suma Publishers, Bangalore/ Tata Mc Graw Hill
2. PSG Design Data, DPV Printers, Coimbatore.

You might also like