Scribd
Upload
4 views9 pages

15 physics 2 q2

Uploaded by

herby
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views9 pages

15 physics 2 q2

Uploaded by

herby
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 9

AP® PHYSICS 2

2015 SCORING GUIDELINES

Question 2
12 points total Distribution
of points
(a)
i) 3 points

For indicating that Req of the entire circuit or the combination of bulbs 2 and 3 1 point
decreases
For indicating a change in I tot or the potential difference across bulb 1 consistent 1 point
with Ohm’s law and the change in Req stated in the response
For indicating a change in brightness consistent with the current or potential 1 point
difference change stated in the response

ii) 3 points

For indicating that P1 =


4(
1 2
e R ) 1 point

For indicating that the new equivalent resistance of the circuit is Req,new = (3 2) R 1 point
Note: Credit is earned if calculation is done in part (i) and used here.
For manipulating equations to show that the power expended by bulb 1 is 1 point
16
Pnew = P
9 1

iii) 1 point

For using or referring to the expression from part (a)(ii) to support the claim made 1 point
in (a)(i) regarding the brightness of bulb 1: e.g., 16 9 > 1 , and indicating an
understanding that brightness is related to power consumption

(b)

i) 1 point

For explaining that the brightness of bulb 2 decreases after the switch is closed 1 point
because it expends less power (or the current through bulb 2 decreases, or the
potential difference across bulb 2 decreases)

ii) 1 point

For a calculation that supports the reasoning in part i 1 point

© 2015 The College Board.


Visit the College Board on the Web: www.collegeboard.org.
AP® PHYSICS 2
2015 SCORING GUIDELINES

Question 2 (continued)
Distribution
of points
(c) 3 points

For indicating in either part (c)i or part (c)ii that brightness is dependent on 1 point
potential difference across the bulb OR on current through the bulb

i)
For a reasonable explanation for why bulb 1 is brighter than bulb 2 1 point
Example: Immediately after the switch is closed, the potential difference across the
capacitor will be zero (like a short in the circuit), so the current through bulb 2
would be zero, which is less than the current through bulb 1.
Note: No points will be awarded for indicating that bulb1 is brighter than bulb 2
with no justification.

ii)
For a reasonable explanation for why bulb 1 is the same brightness as bulb 2 1 point
Example: The current through bulb 2 increases as the potential difference across
the capacitor increases (becomes like an open circuit), so a long time after the
switch is closed, the current through bulb 2 will be equal to the full current
through bulb 1.
Note: No points will be awarded for indicating that bulb 1 is the same brightness
as bulb 2 without a justification.

© 2015 The College Board.


Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
©2015 The College Board.
Visit the College Board on the Web: www.collegeboard.org.
AP® PHYSICS 2
2015 SCORING COMMENTARY

Question 2

Overview

The intent of the question was to assess student understanding of basic parallel and series circuits including
resistors and capacitors. An understanding of Ohm’s law and the relationship between current, voltage,
power, and brightness of lightbulbs was being tested. Students were asked to work qualitatively and
quantitatively, and to be able to relate the two representations.

Sample: P2Q2 A
Score: 12

This full-credit paper is well-written and clearly organized. Details of the student’s reasoning are fully
described.

Sample: P2Q2 B
Score: 8

Part (a)(i) earned 2 points, because there is no indication that bulb 1 becomes brighter. Part (a)(ii) earned 3
points for full credit, and (a)(iii) earned no credit. Part (b) earned 2 points for full credit. Part (c) just earned 1
point for (c)(i). There is no indication in either part (c)(i) or (c)(ii) that brightness is dependent on the
potential difference across a bulb.

Sample: P2Q2 C
Score: 5

Part (a)(i) earned 1 point for correctly relating brightness to current. Parts (a)(ii) and (a)(iii) earned no credit.
Part (b)(i) earned 1 point for explaining the brightness of bulb 2 based on a change in current. Part (b)(ii)
earned no credit. The single junction rule equation does not justify a decrease in current when the switch
is closed. Part (c) earned full credit.

© 2015 The College Board.


Visit the College Board on the Web: www.collegeboard.org.

You might also like