IECEX BAS09.0062
IECEX BAS09.0062
of Conformity
INTERNATIONAL ELECTROTECHNICAL COMMISSION
IEC Certification System for Explosive Atmospheres
for rules and details of the IECEx Scheme visit www.iecex.com
Optional accessory:
Signature:
(for printed version)
Date:
(for printed version)
Baseefa
Rockhead Business Park
Staden Lane
Buxton
Derbyshire
SK17 9RZ
United Kingdom
IECEx Certificate
of Conformity
Certificate No.: IECEx BAS 09.0062 Page 2 of 3
Manufacturing
locations:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements.This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended
STANDARDS :
The equipment and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards
IEC 60079-11:2006 Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
Edition:5
IEC 60079-18:2004 Electrical apparatus for explosive gas atmospheres - Part 18: Construction, test and marking of type of protection
Edition:2.0 encapsulation 'm' electrical apparatus
IEC 60079-7:2006 Explosive atmospheres - Part 7: Equipment protection by increased safety "e"
Edition:4
IEC 61241-1:2004 Electrical apparatus for use in the presence of combustible dust - Part 1: Protection by enclosures "tD"
Edition:1
This Certificate does not indicate compliance with safety and performance requirements
other than those expressly included in the Standards listed above.
Test Report:
GB/BAS/ExTR09.0086/00
EQUIPMENT:
Equipment and systems covered by this Certificate are as follows:
The NEXLED Luminaire comprises a cast aluminium flat rectangular base and a cover with a glass diffuser. The diffuser is attached to the cover with two
screw clips and the cover is attached to the base with four screws. Ingress protection is provided with a silicone rubber gasket between the base and the
diffuser.
The internal arrangement comprises up to eight 1W light emitting diodes mounted onto an aluminium heatsink, an encapsulated electronic control module
and terminal strips. An emergency version is available with a NiCd rechargeable battery pack. The control gear monitors the temperature of the
batteries and reduces the charge to safe levels if the temperature drops below 5°C. A heater may be wrapped round the battery pack in which
case the control gear turns on the heater if the temperature drops below 5°C.
The luminaire is rated 110 to 254V ac or dc, 50/60/0 Hz, 2W to 8W depending upon the number of LED’s fitted.
The enclosure is provided with cable entry holes which must be fitted with Ex e approved cable glands which maintain the ingress protection of the
enclosure