Scribd
Upload
2 views

Direct analysis 1

The document discusses the analysis of steel structures according to AISC 360-10, highlighting the need for adjustments in stiffness reduction methods and national load ratios. It emphasizes the importance of verifying the acceptability of selected methods by the user, as the design module does not perform this verification. Recommendations include changing the national load ratio and using a variable stiffness reduction method for accurate results.

Uploaded by

intimate4life
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2 views

Direct analysis 1

The document discusses the analysis of steel structures according to AISC 360-10, highlighting the need for adjustments in stiffness reduction methods and national load ratios. It emphasizes the importance of verifying the acceptability of selected methods by the user, as the design module does not perform this verification. Recommendations include changing the national load ratio and using a variable stiffness reduction method for accurate results.

Uploaded by

intimate4life
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Steel Seres Check Data AISC 360-10

Fle

unary tor and tei

Cia Conpact PEincpi ot: .000deges

Povison Larb Analysi: Dreee Analyss


B/C Lim=.950 2nd Grdet Genera nd Grder Beduetens Tub fied
ted.s9 A tetord.600

,
Aiphalt/h.t20 Aighalt/že.252 faeto.850

From the previous picturc.


«P
= 0.820 >0.5 # 1.0 TEl 0.8

\assumptíon isincorrect additional flexture stiffness reduction is required ,


Note that the program still use r,E-08 (incorrect value), is thiscase one of two alternative
nay be uscd

Change national load ratio from 0.002 to 0.003.


Change stiffness reduction method to Tau-b variable
(Apply design then unlock the model and run analysis again then apply the design forthe
second time to getcorrect vales)

Conciusion,

To avoid checking the value when the stiffnessreduction mcthod is Tau-b fixed, use
national load ratio -0.003.

National loud ratio -0003is requircd ifdesign Tau-b fixcd,O002 for Tau-b variable)
n general
lease note that thedesign moduledoes not verify the acceptability of the selected method
The user is expected to verify the acceptability of the selected method.
ordetailed explanations please refer to.

You might also like