Scribd
Upload
3 views5 pages

24bme0282 VL2024250505946 Ast05

The document is a laboratory manual for a Basic Electrical and Electronics Engineering course, detailing the realization of single-phase rectifier circuits. It outlines the aim to design half wave and full wave rectifier circuits using PSPICE simulation, including required software and tools. The procedure for creating the circuit, running simulations, and observing results is also provided.

Uploaded by

Suneet Ghosh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3 views5 pages

24bme0282 VL2024250505946 Ast05

The document is a laboratory manual for a Basic Electrical and Electronics Engineering course, detailing the realization of single-phase rectifier circuits. It outlines the aim to design half wave and full wave rectifier circuits using PSPICE simulation, including required software and tools. The procedure for creating the circuit, running simulations, and observing results is also provided.

Uploaded by

Suneet Ghosh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

SCHOOL OF ELECTRICAL ENGINEERING

Laboratory Manual
BEEE102P-Basic Electrical and Electronics Engineering

Name : Ojas Padhye


Reg. No : 24BME0282
Slot : L33+L34
Faculty : Vivekanandan S

VIT – A Place to learn: A Chance to grow


Ex. No.: 5 Date:
Realization of single-phase rectifier circuit

Aim:
To design half wave and full wave rectifier circuit in PSPICE simulation.

Software /Tool required:


ORCAD / PSpice simulator -> Diode Library - D1N4002/4007,
Source Library – Vsin & Ground (GND) – 0(zero) Analog Library – R
Simulation Settings: Analysis Type - Time Domain
Run to time: 40ms (for 2 cycles)
Circuit Diagram:
Single phase Half – wave Rectifier

Single phase Full – wave Rectifier


Model Graph:

Photograph of practical circuit and Graph obtained in Lab

Single phase half wave rectifier


Single phase full wave rectifier
Procedure

1. Create the given circuit diagram in new project file using the general procedure.
2. Create New Simulation Profile and select Time Domain (Transient).
3. Give the run time for two cycles, (i.e. 0.04 seconds for 50Hz frequency for two cycles) and
press OK.
4. Select the voltage differential marker and connect across the input voltage source and load
resistor.
5. Run the simulation and observe the input and output signal variation.

Result:

You might also like