RV3-65D-R4-V3

8-port sector antenna, 2x 694–960 and 6x 1695–2690 MHz, 65°

Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector
All Internal RET actuators are connected in “Cascaded SRET” configuration
Wind Loading; Frontal / Lateral / Rear – 477 / 409 / 506 N @ 150km/h
Supports re-configurable antenna sharing capability enabling control of the internal RET system
using up to two separate RET compatible OEM radios

General Specifications
Antenna Type Sector

Band Multiband

Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket

Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN

Radome Material Fiberglass, UV resistant

Radiator Material Aluminum | Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 6

RF Connector Quantity, mid band 0

RF Connector Quantity, low band 2

RF Connector Quantity, total 8

Remote Electrical Tilt (RET) Information

RET Interface 8-pin DIN Female | 8-pin DIN Male

RET Interface, quantity 2 female | 2 male

Input Voltage 10–30 Vdc

Internal RET High band (3) | Low band (1)

Power Consumption, idle state, maximum 1W

Power Consumption, normal conditions, maximum 8W

3GPP/AISG 2.0 (Single RET) Page 1 of 4

©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RV3-65D-R4-V3
Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions
Width 350 mm | 13.78 in

Depth 208 mm | 8.189 in

Length 2688 mm | 105.827 in

Net Weight, without mounting kit 31.7 kg | 69.886 lb

Array Layout

Port Configuration

Page 2 of 4

©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RV3-65D-R4-V3

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2690 MHz | 694 – 960 MHz

Polarization ±45°

Total Input Power, maximum 800 W @ 50 °C

Electrical Specifications
Frequency Band, MHz 694–790 790–890 890–960 1695–1920 1920–2200 2300–2500 2500–2690
Gain, dBi 16.5 17.3 17.4 17 17.5 18.2 18.2
Beamwidth, Horizontal, 67 64 61 63 63 63 62
degrees
Beamwidth, Vertical, degrees 8.2 7.4 6.8 7.3 6.4 5.6 5.3
Beam Tilt, degrees 0–10 0–10 0–10 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 18 24 23 16 17 16 16
Front-to-Back Ratio at 180°, 31 33 34 35 37 37 37
dB
Isolation, Cross Polarization, 28 28 28 25 28 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150
Input Power per Port at 50°C, 250 250 250 200 200 200 200
Page 3 of 4

©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025
RV3-65D-R4-V3
maximum, watts

Mechanical Specifications
Wind Loading @ Velocity, frontal 477.0 N @ 150 km/h (107.2 lbf @ 150 km/h)

Wind Loading @ Velocity, lateral 409.0 N @ 150 km/h (91.9 lbf @ 150 km/h)

Wind Loading @ Velocity, maximum 1,010.0 N @ 150 km/h (227.1 lbf @ 150 km/h)

Wind Loading @ Velocity, rear 506.0 N @ 150 km/h (113.8 lbf @ 150 km/h)

Wind Speed, maximum 241 km/h (150 mph)

Packaging and Weights

Depth, packed 350 mm | 13.78 in

Length, packed 2830 mm | 111.417 in

Weight, gross 45.7 kg | 100.751 lb

Regulatory Compliance/Certifications
Agency Classification
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Included Products
BSAMNT-4 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 4

©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its
affiliates in the U.S. and other countries. All product names, trademarks and registered trademarks are property of their respective owners.
Revised: March 12, 2025