Solar Energy

.and its many uses

SOLAR ENERGY

A FEW FACTS Every day the earth receives thousands of times more energy from the sun than is consumed in all other resources. If a 140x140 mile parcel of land in Arizona was covered with solar cells, the electricity needs of the entire United States could be met. The sunlight falling on a typical house can provide from 1/3 to 1/2 of the heating needs of that house. Today solar energy accounts for only 1% of the total renewable energy consumed in the United States

Characteristics of Isolation
Isolation is the amount of solar radiation reaching the earth. Also called Incident Solar Radiation. The suns energy is created from the fusion of hydrogen nuclei into helium nuclei. Components of Solar Radiation: Direct radiation Diffuse radiation Reflect radiation

SOLAR HEATING TODAY

Used mostly for heating pools and domestic hot water (DHW) Two types of solar heating systems:
Active Solar Heating System Passive Solar Heating System

ACTIVE SOLAR HEATING SYSTEM

A system that uses water or air that the sun has heated and is then circulated by a fan or pump. Three Types:
Flat Plate Collectors Batch Water Heaters Thermosiphon

FLAT PLATE COLLECTORS

A thin flat metal plate is used to absorb the suns radiation. Tubes carry water into the absorber plate where it is heated by the sun and sent to a pump or fan into storage and distributed from there to the living space.

BATCH WATER HEATERS

Pre-heats water using the sun by having a black tank inside an isolated box with a glass cover. Solar energy is absorbed within the box to heat the water. The water outflow is sent into a conventional water heater for further heating. They are also called BreadBox heaters.

THERMOSIPHEN
This method places the storage tank above the solar collector. Cold water is put into the bottom of the storage tank where it is circulated through a flat plate collector and pumped back into the top of the storage tank. The heated water can then be taken from the top and used.

PASSIVE SOLAR HEATING SYSTEMS

The house itself acts as the solar collector and storage facility. No pumps or fans are used. This system makes use of the materials of the house to store and absorb heat. Three Types:
Direct-Gain Indirect-Gain Attached Greenhouse

DIRECT-GAIN
Large south facing windows that let in the sunlight. Thermal mass is used to absorb the radiation. At night the absorbed heat is radiated back into the living space.

INDIRECT-GAIN
Collects and stores the solar energy in one part of the house and use natural heat transfer to distribute heat to the rest of the house. Popular method is to use a Trombe Wall which is a massive black masonry that acts as a solar collector and a heat storage medium.

ATTACHED GREENHOUSE
Uses a combination of Direct and Indirect-Gain systems that use water drums and a masonry floor as heat storage in the attached greenhouse. Thermosiphoning can use direct-gain from the flow of air created by the difference in pressure between the less dense warmer air of the room and the cooler air near the ground.

THERMAL ENERGY STORAGE

Solar energy heating systems must be able to store energy for night time use and for cloudy days. Different materials absorb different amounts of heat. Depending on the weather and the amount of thermal energy stored will determine how long a house can continue to be heated by the stored solar energy. Phase-change material can be used to add additional heat to the living space.

This House Uses an Active Air System

Photovoltaic Cells use in Energy Production

How cells are built The Photoelectric Effect Pros and Cons of PV

4 types of PV cells
Selective Emitter Cell (SEC) Emitter wrap- through cells (EWC) Thin Film Photovoltaic Single Crystal Silicon Cells

Single-Crystal Silicon Cell Construction

The majority of PV cells in use are the single-crystal silicon type. Silica (SiO2) is the compound used to make the cells. It is first refined and purified, then melted down and re-solidified so that it can be arranged in perfect wafers for electric conduction. These wafers are very thin. The wafers then have either Phosphorous or Boron added to make each wafer either a negative type layer or a positive type layer respectively. Used together these two types treated of crystalline silicon form the p-n junction which is the heart of the solar electrical reaction. Many of these types of cells are joined together to make arrays, the size of each array is dependant upon the amount of sunlight in a given area.

How Does A Cell Become A Module?

A solar cell is the basic building block of a PV system. A typical cell produces .5 to 1V of electricity. Solar cells are combined together to become modules or if large enough, known as an array. A structure to point the modules towards the sun is necessary, as well as electricity converters, which convert DC power to AC. All of these components allow the system to power a water pump, appliances, commercial sites, or even a whole community.

The Photoelectric Effect

The photoelectric effect relies on the principle that whenever light strikes the surface of certain metals electrons are released. In the p-n junction the n-type wafer treated with phosphorus has extra electrons which flow into the holes in the p-type layer that has been treated with boron. Connected by an external circuit electrons flow from the n-side to create electricity and end up in the p-side.

Photoelectric Effect

A picture of an typical silicon PV cell Now a short video: http://www.eere.energy.gov/solar/multimedia.html

 Sunlight is the catalyst of the reaction. The output current of this reaction is DC (direct) and the amount of energy produced is directly proportional to the amount of sunlight put in. Cells only have an average efficiency of 30%

Pros and Cons of Solar Electricity

Expensive to produce because of the high cost of semi- conducting materials, which could be avoided by reducing manufacturing costs. The PV Manufacturing Research and Development Project focuses on increasing manufacturing capacity so that the cost of manufacturing will decrease. They aim to achieve break even costs. However, solar energy contributes positively to the nations energy security because it is produced domestically, reducing reliance on energy imports. The industry is still relatively new and extremely hi tech allowing for the creation of more jobs in the American market. The government has many incentives program which vary from state to state, but they exist to encourage investment in forms of alternative energy. Does not require the transportation of hazardous materials across country. Sunlight is a free abundant source!

Pros and Cons cont.

PV can be designed for a variety of applications No noise or air pollution Require minimal maintenance and have long service life times. Power can be either centralized in individual homes or distributed by electrical companies.

How PV Systems Work

Stand-Alone Photovoltaic Systems Grid-connected

BREAKDOWN
PV systems are like any other electrical power generating systems, except the equipment used to generate the power is different. Specific components required, and may include major components such as a DCAC power inverter, batteries, auxiliary energy sources, sometimes the specified electrical load (appliances), wiring, surge protection and other hardware. Batteries are often used in PV systems for the purpose of storing energy produced by the PV array during the day, and to supply it to electrical loads as needed (during the night and periods of cloudy weather). Also to keep the system at full operational power

Grid-connected or Utility-Connected
Grid-connected or utility-interactive PV systems are designed to operate in parallel with and interconnected with the electric utility grid. These system contain an inverter, called a power conditioning unit (PCU) which converts the DC power produced by the PV array into AC power consistent with the voltage and power quality requirements of the utility grid. A bi-directional interface allows the AC power produced by the PV system to either supply personal electrical loads, or return power back to the grid when the PV system output is greater than the personal demand.

Stand-Alone PV Systems
Stand-alone PV systems are designed to operate independent of the electric utility grid Supply DC and/or AC electrical loads The simplest type of stand-alone PV system is a direct-coupled system, where the DC output of a PV module or array is directly connected to a DC load Since there are no batteries involved in direct load systems, stand-alone PV systems are suitable for such processes as heating and pumping water, ventilation fans, etcAlthough they can only work in the day. Stand-Alone systems may also power AC loads such as batteries. Like the AC adapter which powers your laptop.

The Grid and All of Its Glory

Net metering allows a home or business owner to sell electricity generated by PV modules to the utility grid. This benefits both the consumer, and in some cases the utility. The electric meter will run backward when there is an excess of electricity needed to power a building. A safety measure cuts off the PV system from the grid in case of an emergency. At the End of the Month, the Consumer will reek the benefits.

Benefits to The Economy, Environment, You, and Me

Americans yearn for reliable, clean, abundant, affordable energy, and safe energy. Can prevent catastrophes such as the blackout on Aug 14, 2003. Businesses are in turn investing in solar to avoid these instances Solar electric power systems can be easily sited at the point of use with no environmental impact. The current U.S. solar industry employs some 20,000 men and women in high-value, high-tech jobs, representing about 300 companies, universities, and utilities
Solar thermal collector shipments surged 34% in 2001 to 11.2 million square feet. The total revenue for all shipments of solar thermal collectors was $32.4 million in 2001, up 18% from 2000. Nearly 73% of all solar collectors are for poolheating applications. Solar water heaters comprise the remaining 27% of U.S. solar thermal applications. In 2001, the overall value of PV cell and PV module shipments rose by 13% to $305 million. In terms of price per peak megawatt, prices have remained stable at $2.46 for PV cells and $3.42 for PV modules.

Photovoltaic (PV) systemshave very little impact on the environment, making them one of the cleanest power-generating technologies available . Solar power produces no air pollution. Solar power produces no greenhouse gases, so it does not contribute to global warming.

Production
Combinations of haz and non-haz materials + High temperatures = high environmental cost Cost decline as companies depend more on solar for production of cells/modules

Life
Average 20-30 years Efficiency decrease 1% a year. Research on manufacturing and output efficiency and recycling ongoing. Payback or energy break even - 15 years.

Example of Progressive policy

EU End of Life of Vehicles Policy. PV Industry has a pro-active approach to energy saving/environmental benefit increase etc. Policy can be created like ELV to encourage manufacturers to incorporate breakdown into production.

American Solar Energy Society

The American Chapter of the International Energy Society -Located in Boulder CO- Nations Largest and Oldest Membership Organization for Renewable Energy -Sponsors the National Solar Energy Conference: Held July 10-14, Portland OR -Publishes the Bimonthly Magazine Solar Today -Organizes the Annual National Solar Tour -Organizes the Solar Action Network

 Solar Energy Industries Association (SEIA)

-Provides funding and research for solar advancement technologies -Political group that spends much energy lobbying on behalf of solar power and other renewable resources -14 state SEIA Organizations

Solar Energy Business Association of New England (SEBANE) -Centered in Boston, MA; services the entire New England
Area

Vermont Based Solar Providers

Vermont Solar Businesses that are Members of SEBANE: Northern Power Systems Northern Power Systems designs, builds and installs high reliability electric power systems. Northern has installed over 800 systems worldwide in the past 25 years, earning a reputation for delivering top-quality energy solutions. Northern provides photovoltaic, wind and wind/diesel hybrid power for commercial, industrial, institutional and government clients.

Vermont Based Solar Providers

Solar Works, Inc. Since 1980, Solar Works, Inc., has provided renewable energy services and equipment to government agencies, utilities, private businesses, homeowners, and not-for-profit organizations in the United States and overseas. As a full-service renewable energy firm, Solar Works maintains sales offices in California, Connecticut, Maine, Maryland, Massachusetts, New Hampshire, New Jersey, New York, Rhode Island, and Vermont. Our experience includes: program development, project management, and the design and installation of Photovoltaic (Solar Electric or PV) Systems, Solar Thermal Systems (both active and passive), High-efficiency Lighting and Heating systems, and small-scale Wind Turbines.

Vermont Based Solar Companies

Sunnyside Solar, Inc. Sunnyside Solar, Inc. is a full service photovoltaic company specializing in line-tie and stand alone photovoltaic systems. Design, & engineering, equipment sales, full service & installation capabilities. Educational programs seminars and workshops. Sunnyside Solar, Inc. The gentle electric company. We bring good things from light!

Sunrise Solar Service Sunrise Solar Service installs, sells, and services domestic hot water systems, pool heating, water pumping, lighting systems, and system components and supplies.

Sources
http://www.eere.energy.gov/solar/photovoltaics.html http://www.fsec.ucf.edu/pvt/pvbasics/index.htm42 http://www.brookes.ac.uk/eie/elv.htm http://www.environmentaldefense.org/documents/894_ GC_takeback.htm

Contact Information
Northern Power Systems
Jito Coleman President P.O. Box 999 182 Mad River Park Waitsfield, VT 05673-0999

Solar Works, Inc.

Leigh Seddon President 64 Main Street Montpelier, VT 05602

Sunnyside Solar, Inc.

Richard Gottlieb 1014 Green River Road Guilford, VT 05301-8117

Sunrise Solar Service

Ed Butler P.O. Box 129 454 Hunt Road Randolph, VT 05060