Data and Computer Communications

Chapter 8 Multiplexing

Eighth Edition by William Stallings Lecture slides by Lawrie Brown

Multiplexing
It was impossible to get a conversation going, everybody was talking too much. Yogi Berra

Multiplexing
multiple

links on 1 physical line common on long-haul, high capacity, links have FDM, TDM, STDM alternatives

Frequency Division Multiplexing

FDM System Overview

FDM Voiceband Example

Analog Carrier Systems

long-distance links use an FDM hierarchy AT&T (USA) and ITU-T (International) variants Group

12 voice channels (4kHz each) = 48kHz in range 60kHz to 108kHz FDM of 5 group signals supports 60 channels on carriers between 420kHz and 612 kHz FDM of 10 supergroups supports 600 channels

Supergroup

Mastergroup

so original signal can be modulated many times

Wavelength Division Multiplexing

FDM with multiple beams of light at different freq carried over optical fiber links

commercial systems with 160 channels of 10 Gbps lab demo of 256 channels 39.8 Gbps multiplexer consolidates laser sources (1550nm) for transmission over single fiber Optical amplifiers amplify all wavelengths Demux separates channels at the destination

architecture similar to other FDM systems

also have Dense Wavelength Division Multiplexing (DWDM)

Synchronous Time Division Multiplexing

TDM System Overview

TDM Link Control

no headers and trailers data link control protocols not needed flow control

data rate of multiplexed line is fixed if one channel receiver can not receive data, the others must carry on corresponding source must be quenched leaving empty slots errors detected & handled on individual channel

error control

Data Link Control on TDM

Framing

no flag or SYNC chars bracketing TDM frames must still provide synchronizing mechanism between src and dest clocks added digit framing

one control bit added to each TDM frame identifiable bit pattern used on control channel eg. alternating 01010101unlikely on a data channel compare incoming bit patterns on each channel with known sync pattern

Pulse Stuffing

have problem of synchronizing data sources with clocks in different sources drifting also issue of data rates from different sources not related by simple rational number Pulse Stuffing a common solution

have outgoing data rate (excluding framing bits) higher than sum of incoming rates stuff extra dummy bits or pulses into each incoming signal until it matches local clock stuffed pulses inserted at fixed locations in frame and removed at demultiplexer

TDM Example

Digital Carrier Systems

long-distance links use an TDM hierarchy AT&T (USA) and ITU-T (International) variants US system based on DS-1 format can carry mixed voice and data signals 24 channels used for total data rate 1.544Mbps each voice channel contains one word of digitized data (PCM, 8000 samples per sec) same format for 56kbps digital data can interleave DS-1 channels for higher rates

DS-2 is four DS-1 at 6.312Mbps

DS-1 Transmission Format

SONET/SDH
Synchronous

Optical Network (ANSI) Synchronous Digital Hierarchy (ITU-T) have hierarchy of signal rates

Synchronous Transport Signal level 1 (STS-1) or Optical Carrier level 1 (OC-1) is 51.84Mbps carries one DS-3 or multiple (DS1 DS1C DS2) plus ITU-T rates (eg. 2.048Mbps) multiple STS-1 combine into STS-N signal ITU-T lowest rate is 155.52Mbps (STM-1)

SONET Frame Format

Statistical TDM
in

Synch TDM many slots are wasted Statistical TDM allocates time slots dynamically based on demand multiplexer scans input lines and collects data until frame full line data rate lower than aggregate input line rates may have problems during peak periods

must buffer inputs

Statistical TDM Frame Format

Cable Modems

dedicate two cable TV channels to data transfer each channel shared by number of subscribers, using statistical TDM Downstream

cable scheduler delivers data in small packets active subscribers share downstream capacity also allocates upstream time slots to subscribers
user requests timeslots on shared upstream channel Headend scheduler notifies subscriber of slots to use

Upstream

Cable Modem Scheme

Asymmetrical Digital Subscriber Line (ADSL)

link between subscriber and network uses currently installed twisted pair cable is Asymmetric - bigger downstream than up uses Frequency division multiplexing

reserve lowest 25kHz for voice (POTS) uses echo cancellation or FDM to give two bands

has a range of up to 5.5km

ADSL Channel Configuration

Discrete Multitone (DMT)

multiple carrier signals at different frequencies divide into 4kHz subchannels test and use subchannels with better SNR 256 downstream subchannels at 4kHz (60kbps)

in theory 15.36Mbps, in practice 1.5-9Mbps

DMT Transmitter

xDSL
High

data rate DSL (HDSL)

2B1Q coding on dual twisted pairs up to 2Mbps over 3.7km

Single

line DSL

2B1Q coding on single twisted pair (residential) with echo cancelling up to 2Mbps over 3.7km

Very

high data rate DSL

DMT/QAM for very high data rates over separate bands for separate services

Summary
looked

at multiplexing multiple channels on a single link FDM TDM Statistical TDM ADSL and xDSL