Scribd
Upload
53 views26 pages

Science Fair Procedures

This document describes the procedures for building a paper speaker as a science fair project. It involves cutting paper strips to wrap around a magnet, winding magnet wire around a paper tube, and connecting the paper speaker to an audio device to test the volume produced using temporary and permanent magnets. The student is to record the average decibel levels produced by 5 temporary magnets and 5 permanent magnets in a data table.

Uploaded by

Paramasivam Kandasamy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
53 views26 pages

Science Fair Procedures

This document describes the procedures for building a paper speaker as a science fair project. It involves cutting paper strips to wrap around a magnet, winding magnet wire around a paper tube, and connecting the paper speaker to an audio device to test the volume produced using temporary and permanent magnets. The student is to record the average decibel levels produced by 5 temporary magnets and 5 permanent magnets in a data table.

Uploaded by

Paramasivam Kandasamy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 26

SJKT LADANG MIDLANDS

SCIENCE FAIR

PAPER SPEAKER

FUNCTION OF SPEAKER

APPARATUS

PROCEDURES

1) Cut two strips of paper 20cm


long with 2 cm width.

2) Wrap 1 stripe of paper


tightly around the magnet.

3) Prepare two paper tubes (one


with slightly larger diameter)

4) Make sure the stack of


magnet fits inside the larger
tube with a gap between them.
Remove the smaller paper tube.

5) The magnet need to be able


to slide back and forth inside
the larger tube without touching
the wall.

6) Use a small piece of tape to


attach the magnet wire to
paper tube.

5) Prepare about 3m of wire out


of the spool of magnet.

7) Neatly wrap 50 turns of wire


still attached to the spool
around the paper tube.

8) Completely wrap tape around


the wire will to prevent it from
unravelling.

9) Remove the magnets from


the tube.

10) Rub the end of the magnet


wire with sand paper.

11) Fold two business cards


into M shape.

12) Glue the paper tube and


business cards on the back of
the plate.

13) Glue the free ends of the


business cards on a cardboards
base.

14) Stick the stack of magnet on


the center of a business card.

15) Magnet inserted into wire


coil.

16) Connect audio device,


amplifier and paper speaker.

17) Test the paper speaker with


1000hz test tone and collect
date.

18) Calculate an average volume


in decibels and record the
values in data table for 5
temporary magnets and 5
permanent magnets.

MODEL

You might also like