Scribd
Upload
147 views10 pages

Removing 6634 UEPP: Complete A Shutdown On The Core and Power Off The ATM Before You Start To Remove The Uepp

1. Shutdown the ATM and power off before removing the UEPP. Remove the right side panel to access components. 2. Rack out all modules to access the LCD, touch screen, and shutters. Disconnect related harnesses. 3. Remove the LCD monitor by disengaging plungers, pulling the handle upwards and rotating plungers 90 degrees. Remove shipping screws if present.

Uploaded by

رانا راشد
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
147 views10 pages

Removing 6634 UEPP: Complete A Shutdown On The Core and Power Off The ATM Before You Start To Remove The Uepp

1. Shutdown the ATM and power off before removing the UEPP. Remove the right side panel to access components. 2. Rack out all modules to access the LCD, touch screen, and shutters. Disconnect related harnesses. 3. Remove the LCD monitor by disengaging plungers, pulling the handle upwards and rotating plungers 90 degrees. Remove shipping screws if present.

Uploaded by

رانا راشد
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 10

Removing 6634 UEPP

Complete a
shutdown on the
core and power
off the ATM
before you start
to remove the
UEPP

1. From the rear of the ATM, remove right side panel


If there is no access on the right side, then all work from the
back will have to be over the safe.
2. Rack all modules out to access the LCD, Touch Screen and
Shutters.
Remove the LCD monitor harnesses

USB to Touch
Screen Light Sensor
DC Power
Video

4. Disconnect the harnesses, you may leave the video cable connected
Remove the LCD Monitor

Plunger

Handle If the shipping screws are present


There would be one above each Plunger
Plungers

5. Remove shipping screws, if they are still present.


6. To disengage the plungers and keep them out, pull plunger out and rotate it 90
degrees
7. Pull the handle upwards and back, place LCD in the area of the Statement printer
module. Remember the video harness is still connected.
Note the monitor is mounted by two pins on each side.

Plunger
Remove the Touch Screen

Retaining Wires Latches Press down on each latch

7. Press down on each latch and push the top of the Touch Screen out toward
the front of the ATM
Note the retaining wires will catch the Touch Screen while you walk around to
the front of the ATM to finish removing the Touch Screen
Finish Removing the Touch Screen

8. From the front of the ATM remove the retaining wire loops off the studs and place the
Touch Screen in a safe place
Remove the shutters

9. Disconnect the USB and power harnesses from the shutters


10. Remove the two screws for each shutter
11. From the view in the picture, remove the right shutter first. Pull up to remove the shutter
from the studs. See next page for additional views.
Front view of a shutter

Stud Screws
Remove the keyboard support plate

Screw

Note: The picture was taken with the dispenser shutter still in the ATM. Please remove it first.

12. Remove screw and slide the keyboard support plate back and remove it from the ATM. The keyboard will drop
down.
13. Slide keyboard back and out of the ATM, disconnect the harnesses on the keyboard. See next page for additional
details.
Viewed from the front of the ATM

Keyboard Support Plate Keyboard slid back

14. Reverse order, for assembly of components

You might also like