Computer Numerical Control: Standards For CAD
Uploaded by
ibraheemComputer Numerical Control: Standards For CAD
Uploaded by
ibraheemComputer Numerical Control
Lecture 11
Standards for CAD
Dr Lina Momani
Standards for dimensioning
v
According to the American National Standards Institute ANSI standards, the
following are the basic rules that should be observed in dimensioning
any drawing:
1. Show enough dimensions so that the intended sizes and shapes can be
determined without calculating or assuming any distances.
2. State each dimension clearly, so that it can be interpreted in only one
way.
3. Show the dimensions between points, lines, or surfaces that have a
necessary and specific relation to each other or that control the location
of other components or mating parts.
4. Select and arrange dimensions to avoid accumulations of tolerances
that may permit various interpretations and cause unsatisfactory
mating of parts and failure in use.
07/09/2020 2
Standards for dimensioning
5. Show each dimension only once.
6. Where possible, dimension each feature in the view where
it appears in profile, and where its true shape appears.
7. Wherever possible, specify dimensions to make use of
readily available materials, parts, tools, and gauges.
Savings are often possible when drawings specify (a)
commonly used materials in stock sizes, (b) parts generally
recognized as commercially standard, (c) sizes that can be
produced with standard tools and inspected with standard
gauges, and (d) tolerances from accepted published
standards.
07/09/2020 3
Conventional tolerancing
Since it is impossible to produce the exact dimension specified, a
tolerance is also used to show the acceptable variation in a dimension.
The higher the quality a product has, the smaller the tolerance value
specified. Tighter tolerances are translated into more careful
production procedures and more rigorous inspection. There are two
types of tolerances: bilateral tolerance and unilateral tolerance (as
shown in the following Figure). Unilateral tolerances, such as ,
specify dimensional variation from the basic size (i.e., decrease) in one
direction in relation to the basic size; for example,
1.00 00..00
05
The basic location where most dimension lines originate is the
reference location (datum). For machining, the reference location
provides the base from which all other measurements are taken. By
stating tolerance from a reference location, cumulative errors can be
eliminated.
1.00 00..00
05 0.95 1.00
07/09/2020 4
Conventional tolerancing
07/09/2020 5
Conventional tolerancing
Surface control symbols
07/09/2020 6
Conventional tolerancing
Lay symbols
07/09/2020 7
Dimensioning
07/09/2020 8
TOLERANCE
Dimensional tolerance - conventional
Geometric tolerance – modern
REASON OF HAVING TOLERANCE
• No manufacturing process is perfect.
• Nominal dimension (the "d" value) can not be achieved exactly.
• Without tolerance we lose the control and as a consequence cause
functional or assembly failure.
07/09/2020 9
TOLERANCE
07/09/2020 10
TOLERANCE STACKING
1. Check that the tolerance & dimension specifications are reasonable for
assembly.
2. Check there is no over or under specification.
07/09/2020 11
TOLERANCE STACKING
07/09/2020 12
TOLERANCE STACKING
07/09/2020 13
TOLERANCE GRAPH
07/09/2020 14
