Scribd
Upload
45 views

Put A New Sketch: Intersecting Middle

Uploaded by

api-294653971
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
45 views

Put A New Sketch: Intersecting Middle

Uploaded by

api-294653971
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 26

Step 13.

1 – Bolt Shank
• Put a new sketch
intersecting middle.
Step 13.2 – Bolt Shank
• Put a new sketch intersecting
middle.
• 1” Long X 0.1875in(Half of 3/8”)
with a 21.5° bevel on thread end.
Step 13.3 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 13.4 – Revolve It
• Click on Revolve Tool
• Revolve the part 360° Boolean set to
ADD
Step 14.1 – Built in Washer
• Put a new sketch on the
end of the shank.
Step 14.2 – Circle

• Put a 0.5”
Circle
aligned
with the
Origin.
Step 14.3 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 15.1 – Extrude It
• Extruded
the circle
drawing
0.0325”.
Step 16.1 – New Sketch
• Put a new sketch on the end.
Step 16.2 – Polygon
• Put a new
Polygon.
Step 16.3 – 9/16” Hex Head
• Put a Hex.
• Size it at 9/16”
(0.5625)
Step 16.4 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 17.1 – Extrude It
• Extrude
the Hex
Head
Sketch ¼”
(0.25).
Step 18.1 – New Sketch
• Put a new sketch intersecting middle.
Step 18.2 – New Sketch – F7 View
• At the
Middle
Point
going to
place a
Locked
Constru
ction
Line.
Step 18.3 – New Sketch
• Draw a 60°
Triangle.
Step 18.4 – New Sketch

• Instead of redrawing it, I mirrored


again...
Step 18.5 – Revolution Line

• Place a Locked Construction


Line from Origin out.
Step 18.6 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 19.1 – Revolve It

• Revolve
& Cut
Away
360°.
Step 20.1 – New Sketch
• Put a
new
sketch
on the
end of
the
bolts
head.
Step 20.2 – Bolt Grade Markings
• Hardware
comes in
different
Grades.
• Metric
used
Numbers.
• Standard
uses
radial
lines.
Step 20.3 – Standard Bolt
Grades Markings
Step 20.4 – Lines
• Made a
vertical
locked
constructi
on line
0.2 inches
long.

• I made a 0.02” x 0.95”


vertical drawing.
Step 20.5 – Copy in a Circular Pattern
• Click on
Circular
Pattern
Tool.
• Select the
Quantity of
3.
• Axis Point
of the
Origin.
Step 20.6 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.

You might also like