Scribd
Upload
30 views

Times, & Height Just Over The Height of The Thickness of The Washer 0.063"

Uploaded by

api-294653971
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
30 views

Times, & Height Just Over The Height of The Thickness of The Washer 0.063"

Uploaded by

api-294653971
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 17

Step 19.

1 – Click on the Coil Tool

• Yes, Revolve it more than 1, I did 1.030


Times, & Height just over the height of the
thickness of the washer 0.063”.
Step 19.2 – Overlap

• Now we will “Cut” the part along


the split.
Step 19.3 – Put in a 3 Point Plane

• One way to insert a new plane is


called 3 point plane.
• Uses 3 points to set the plane.
Step 19.4 – Put in a 3 Point Plane

• Select these 3 Points & the new plane should


appear.
Step 20.1 – Put in a new Sketch
• Put a new sketch
on the plane.
• The F7 Button will
“Cut” the part in
half along the
sketch you are in.
Let’s you draw
inside the part!
• Then draw a
shape, I did a
rectangle.
Step 20.2 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 21.1 – Extrude Cut

• I did a 2 direction cut of


0.045” & 0.018”
Step 21.2 – Extrude Cut

• The diagonal split is now created


in our split locking washer.
Step 22.1 – Material & Color

• Set it to Mild Steel & Semi-


Polished
Step 22.2 – Drawing
• I put it into an Drawing then put in the
Annotations & Notes.
Step 23.1 – Test Fit
Step 24.1 – Flat Washer
• New Part draw the following
Step 24.2 – Finished
• Clicked
Finished /
Exit to finish
the drawing /
sketch.
Step 25.1 – Revolve It

• Flat Washer Created…


Step 25.2 – Material & Color
• Set it to Mild Steel & Semi-Polished
Step 25.3 – Drawing
• I put it into an Drawing then put in the
Annotations & Notes.
Step 25.4 – Test Fit

• Test fit the washer on your bolt.


• DONE!

You might also like