Scribd
Upload
13 views

ATS From Three Sources

Uploaded by

Syed arefin
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
13 views

ATS From Three Sources

Uploaded by

Syed arefin
Copyright
© © All Rights Reserved
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 17

Development of a Smart Automatic Transfer Switch from

Three Different Source


Supervised By Presented By
Hafiz Al Mahmud MD. ATIQUR RAHMAN
Lecturer MD. FERDOUS HOSSAIN
Department of Electrical and MD. TIPU PRAMANIK
Electronic Engineering SOWTARA

EUROPEAN UNIVERSITY OF BANGLADESH


OUTLINE
 INTRODUCTION
 OBJECTIVE
 METHODOLOGY
 MAIN COMPONENTS
 ARDUINO UNO
 BLOCK DIAGRAM
 CIRCUIT DIAGRAM
 WORKING PRINCIPLE
 PROJECT PICTURE
 ADVANTAGE
 DISADVANTAGE
 APPLICATION
 FUTURE SCOPE
 CONCLUSION
INTRODUCTION

The main aim of any electric power supply is to provide uninterrupted power
supply at all times to all its consumers.
 This project is a design of an automatic changeover switch.
 when there is any mains failure, the automatic changeover switch will
change to an alternative power supply
Objective
 To design a solar and battery backup and automatic transfer switch system which will offer protection
against equipment damage and data loss.
 To Utilize Solar Power.
 To Reduce fuel costing of generator
 To Test and Analyze.
Methodology
 Creating an idea for design and construction of auto transfer switch

 Collecting the all components and programming for the microcontroller to


controlled the system.

 Setting all components in a board & soldering. Then assembling the all block
in a board and finally run the system & checking.
Main Components
 Arduino Uno
 Voltage Sensor
 LCD Display
 Relay Module
 Inverter
 Solar Panel
 Buck Converter
Arduino UNO

 The Arduino Uno is a microcontroller board


based on the ATmega328p.
 Arduino is an open-source, prototyping
platform and its simplicity makes it ideal for
any types of project to use as well as
professionals and Students.
BLOCK DIAGRAM
Circuit Diagram
Working Principle
 In general condition when main source is active then 50% load is supply from main
and another 50% load supply from solar.
 If solar battery voltage is less than 11V then Load will supply from main line.
 If main line is not available then 100% load supply from solar source.
 If solar and main line both are not available then 100% load are get supply from
Generator.
Project Picture
Advantage
 Easy to install
 Fully automated
 No maintenance cost
 No need to press switch
 Information transfers instantly
Disadvantage
 High initial cost
 Battery and inverter need to be use according to load
 Applicable for single phase load
Application
This project can be used at
 Home
 Industry
 Commercial office
 Corporate office etc
Future Scope

 Current sensor can be add for measure consumed power of solar, main and generator.
 SD card and RTC module may add to keep store source usable time for future data
analysis.
 IOT can be implement by using Wi-Fi/Ethernet to transfer usable source status.
CONCLUSION

 An ATS is an electrical device for transferring power sources to an electrical load.

 It will help to save lives, reduce percentage of accident and reduce waste of time. The
program we embedded in the micro controller works as we predicted.

 According to the study and analysis of various parts of the system, a design has been carried
out.

 The results obtained from the measurement shows that the system performs well under all
the conditions.
Thank You

You might also like