Scribd
Upload
5 views

Etabs Modelling

Uploaded by

Sahil Chettri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
5 views

Etabs Modelling

Uploaded by

Sahil Chettri
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 60

ETABS MODELLING

COLUMN LAYOUT
GRID SPACING EDITING
DEFINING STOREY LEVELS
DEFINE MATERIALS
DEFINE SECTION SIZES
CREATE COLUMNS
ASSIGNING SUPPORTS
REPLICATE COLUMNS
CREATE BEAMS FOR GROUND FLOOR
CREATING JOINTS AT PLACES WHERE
THERE ARE NO GRIDS
CREATE BEAMS FOR 1ST FLOOR
REPLICATE BEAMS FOR SUCCESSIVE
FLOORS
ADDING RESTRAINTS FOR SECONDARY
BEAMS
ADD SLABS
REPLICATE SLABS FOR SUCCESSIVE FLOORS
CREATE STAIRCASE FOR BUILDING
CREATE REFERENCE POINTS
CREATE REFERENCE PLANES
CREATE DIAPHRAGMS FOR EACH
FLOOR LEVEL
Just perform check to see if all assignments
are valid till this point
DEFINE LOAD PATTERNS
ASSIGN LOADS UNDER DIFFERENT
LOAD PATTERNS
All outer wall loads
Inner wall load assignment
Parapet wall loading
Floor Finish
Roof Finish
Water Tank Load
Live Load Assignment
Roof Live
SIESMIC LOADING
MESHING OF SLABS
MESHING OF FRAMES
Define Mass Source
LOAD COMBINATIONS
CHECK MODEL
RUN ANALYSIS
RUN CONCRETE DESIGN
CHECK FOR FAILED MEMBERS
REDESIGN SECTION FOR FAILED
MEMBERS
• Select the failed members and change the section size
• Rerun the analysis.
BEAM-COLUMN CAPACITY RATIO

This ratio should be less than 1, else redesign


IDENTIFY ALL FAILURES

If there is any failure, the type of failure will be


mentioned in the respective frame
Display Results

Moment and shear force at different


elevations can be checked here
EXPORT TO EXCEL FOR FURTHER ANALYSIS
This can be exported to excel to design footing

You might also like