Hydropower plant
- 4. • Water reservoir: • In a reservoir the water collected from the catchment area is stored behind a dam. • Catchment area gets its water from rain and streams. • The level of water surface in the reservoir is called Head water level. Note : Continuous availability of water is a basic necessity for a hydro-electric power plant. • Dam : • The purpose of the dam is to store the water and to regulate the out going flow of water. • The dam helps to store all the incoming water. It also helps to increase the head of the water. In order to generate a required quantity of power it is necessary that a sufficient head is available.
- 5. • Spillway: • Excess accumulation of water endangers the stability of dam construction. Also in order to avoid the over flow of water out of the dam especially during rainy seasons spillways are provided. This prevents the rise of water level in the dam. • Spillways are passages which allows the excess water to flow to a storage area away from the dam. • Gate : • A gate is used to regulate or control the flow of water from the dam. • Pressure tunnel: • It is a passage that carries water from the reservoir to the surge tank.
- 6. • Surge tank: • A Surge tank is a small reservoir or tank in which the water level rises or falls due to sudden changes in pressure. Purpose of surge tank: • To serve as a supply tank to the turbine when the water in the pipe is accelerated during increased load conditions and as a storage tank when the water is decelerating during reduced load conditions. • To reduce the distance between the free water surface in the dam and the turbine, thereby reducing the water- hammer effect on penstock and also protect the upstream tunnel from high pressure rise. Water-hammer effect : • The water hammer is defined as the change in pressure rapidly above or below normal pressure caused by sudden change in the rate of water flow through the pipe, according to the demand of prime mover i.e. turbine.
- 7. • Penstock: • Penstock is a closed pipe of steel or concrete for supplying water under pressure to the turbine. • Inlet valve : • Water from the penstock flows to the turbine through the inlet valve. The valve may be partially closed or open thereby regulating the pressure of water flowing to the turbine. • Hydraulic turbine(Prime mover) : • The hydraulic turbine converts the energy of water into mechanical energy. The mechanical energy(rotation) available on the turbine shaft is coupled to the shaft of an electric generator and electricity is produced. The water after performing the work on turbine blades is discharged through the draft tube. • The prime movers which are in common use are Pelton wheel, Francis turbine and Kaplan turbine.
- 8. • Draft tube: • It is connected to the outlet of the turbine. • It allows the turbine to be placed above the tail water level. • Tail water level or Tail race: • Tail water level is the water level after the discharge from the turbine. The discharged water is sent to the river, thus the level of the river is the tail water level. • Electric generator, Step-up transformer and Pylon : • As the water rushes through the turbine, it spins the turbine shaft, which is coupled to the electric generator. The generator has a rotating electromagnet called a rotor and a stationary part called a stator. The rotor creates a magnetic field that produces an electric charge in the stator. The charge is transmitted as electricity. The step-up transformer increases the voltage of the current coming from the stator. The electricity is distributed through power lines also called as pylon.
- 9. Thank you
- 10. Thank you