Scribd
Upload
23 views

Sample Design For MFG Report PDF

The document provides a design for manufacturability review of a part. It notes that a slide will be required to produce the part shape and that thick areas may sink or warp. It recommends modifying ribs and bosses to better accommodate the material and notes some areas will require EDM work.

Uploaded by

janaaidaas
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
23 views

Sample Design For MFG Report PDF

The document provides a design for manufacturability review of a part. It notes that a slide will be required to produce the part shape and that thick areas may sink or warp. It recommends modifying ribs and bosses to better accommodate the material and notes some areas will require EDM work.

Uploaded by

janaaidaas
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Project No: 284908 Part Name: New Q sample v3d_5.

STEP

Quickparts FREE Design for Manufacturing Analysis


Sample Report

Design for Manufacturability Review

Project No: 284908 Part Name: New Q sample v3d_5.STEP

Parting line to be in this area. A slide will be required to produce this shape.

Design for Manufacturability Review The red and yellow areas may sink and or warp

Project No: 284908 Part Name: New Q sample v3d_5.STEP

The recommended wall thickness for PP is from .025 to .150. This part has areas that exceed this thickness and may sink or warp. Can they be cored out?

Design for Manufacturability Review

Project No: 284908 Part Name: New Q sample v3d_5.STEP

Ribs/bosses should be 1/2 to 2/3 of the nominal wall thickness. Taper of 1/2 deg. per side is typical. Ribs/bosses that exceed the 2/3 wall thickness can produce sink marks. Can the ribs/bosses be modified to accommodate the material better?

Design for Manufacturability Review

Project No: 284908 Part Name: New Q sample v3d_5.STEP

These areas will require EDM work to produce this feature as designed.

Design for Manufacturability Review

Project No: 284908 Part Name: New Q sample v3d_5.STEP

These areas will require EDM work to produce this feature as designed.

Design for Manufacturability Review

Project No: 284908 Part Name: New Q sample v3d_5.STEP

Can the Gate location be in this area? The gate size may vary according to part geometry and material selection.

You might also like