Scribd
Upload
37 views

Assignment 1.1

This assignment covers several topics in electronics including rectification, Zener diodes, operational amplifiers, and diode circuits. It contains 5 questions: 1) Describe half wave and full wave rectification with waveforms and discuss the characteristic curve of a Zener diode. 2) Design a Zener diode voltage regulator circuit. 3) Calculate the voltage gain and output of an op-amp circuit. 4) Determine the value of a resistor in a non-inverting op-amp circuit given the output voltage. 5) Calculate currents and voltages in a diode circuit with a switch. The assignment is out of 20 total marks.

Uploaded by

FaIz Fauzi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
37 views

Assignment 1.1

This assignment covers several topics in electronics including rectification, Zener diodes, operational amplifiers, and diode circuits. It contains 5 questions: 1) Describe half wave and full wave rectification with waveforms and discuss the characteristic curve of a Zener diode. 2) Design a Zener diode voltage regulator circuit. 3) Calculate the voltage gain and output of an op-amp circuit. 4) Determine the value of a resistor in a non-inverting op-amp circuit given the output voltage. 5) Calculate currents and voltages in a diode circuit with a switch. The assignment is out of 20 total marks.

Uploaded by

FaIz Fauzi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Assignment # 1

Course: EECE 1312 Semester II 2015/2016 Total Marks 20

Question # 1

i. Describe the working principal of half wave and full wave rectification.
Support your answer with suitable waveform along with phase angle.

ii. Discuss a characteristic curve of Zener diode with forward and reverse region.

iii. Drive the voltage output expression of summing and integrator operational
amplifier, also include circuit diagram.

Question # 2
Design a Zener diode voltage regulator circuit as shown in Figure.1 Consider voltage
regulator is used to power a mobile phone at 3 V from the lithium ion battery, which
voltage may vary between 3.2 V and 3.8 V. The current in the mobile phone will
vary 0 (off) to 150 mA .

Figure no: 1
Question # 3
Calculate the voltage gain and output voltage VO of the operational amplifier circuit
as shown below.

Question # 4
The output voltage of the non-inverting op-amp circuit shown below is 9.5V.
Determine the value of the resistor R1.
Question # 5
The circuit shown below has 3 identical diodes, Is =10-12 A for each of them.
i. Assume that the switch S is opened. Find the value of the current I
required to obtain an output voltage vo = 3V. How much current will
flow in RL ?
ii. Assume that the switch S is closed. Find the value of the output voltage
vo if you know that the current I=1.8mA and the current flowing in RL
is 1.5mA.

You might also like