Scribd
Upload
88 views

Mass Spring Lab Guide

The document provides tips for using the PhET Masses and Springs simulation. It notes several non-obvious controls in the simulation including how potential energy is calculated and how to adjust the stiffness of one spring. It also recommends zooming in for precise measurements and mentions that most objects on the screen are draggable. Important modeling notes are provided, such as keeping masses in view for full energy analysis and that kinetic energy won't be calculated if moving objects with the mouse. Suggestions for using the simulation include starting without friction, using it for concepts introduction, reinforcement, and visualization. Guidelines and teaching resources are referenced for effective classroom use.

Uploaded by

Hidajeta Đedović
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
88 views

Mass Spring Lab Guide

The document provides tips for using the PhET Masses and Springs simulation. It notes several non-obvious controls in the simulation including how potential energy is calculated and how to adjust the stiffness of one spring. It also recommends zooming in for precise measurements and mentions that most objects on the screen are draggable. Important modeling notes are provided, such as keeping masses in view for full energy analysis and that kinetic energy won't be calculated if moving objects with the mouse. Suggestions for using the simulation include starting without friction, using it for concepts introduction, reinforcement, and visualization. Guidelines and teaching resources are referenced for effective classroom use.

Uploaded by

Hidajeta Đedović
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PhET Tips for Teachers

Masses and Springs

Non-obvious controls:

The zero position for Potential Energy is just below the table top where the
masses sit. The draggable dotted line is just something handy.

All the springs have the same characteristics by default. The stiffness of spring
number three can be varied. Put the slider in the middle to reset.

To reset the energy graph, take the mass off the spring. If it is hard to release a
mass, slow it down by adjusting time or a slider.

Most things on the screen are draggable: the ruler, the dotted line, and masses.

There is a zoom feature for all Flash simulations. Right click on the sim and select
Zoom in. This can be helpful when you are using a projector or writing a lesson
where you want a screen shot.
The horizontal dotted line and ruler are movable to be helpful for
relative reference. The bottom of the spring will provide numbers
that are easy to make relationships.

Important modeling notes / simplifications:

Keep the masses in the window for thorough energy analysis because the PE for the
graph is calculated as an absolute value.

The KE will not be calculated if you are moving the cylinder with the mouse

The acceleration due to gravity for earth is set at 9.8 m/s2


Insights into student use / thinking:
You may want the students to start with No Friction
For precise measuring, use Zoom In (by right clicking).
Suggestions for sim use:
For tips on using PhET sims with your students see: Guidelines for Inquiry
Contributions and Using PhET Sims
The simulations have been used successfully with homework, lectures, in-class activities,

or lab activities. Use them for introduction to concepts, learning new concepts,
reinforcement of concepts, as visual aids for interactive demonstrations, or with in-class
clicker questions. To read more, see Teaching Physics using PhET Simulations
For activities and lesson plans written by the PhET team and other teachers, see:
Teacher Ideas & Activities

Written by Trish Loeblein and Mike Dubson, last updated June 2011

You might also like