Scribd
Upload
285 views

Flexural Analysis of Singly Reinforced Beam Using Mathcad Prime

This document summarizes the flexural analysis of a singly reinforced rectangular beam. The beam is 250mm wide and 400mm tall with 5 bars of 20mm diameter reinforcement. The required strength of the beam is 80 kN-m of bending moment. The analysis found that the calculated flexural capacity of 82.58 kN-m exceeds the required strength, so the beam design is safe.

Uploaded by

Yan Yan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
285 views

Flexural Analysis of Singly Reinforced Beam Using Mathcad Prime

This document summarizes the flexural analysis of a singly reinforced rectangular beam. The beam is 250mm wide and 400mm tall with 5 bars of 20mm diameter reinforcement. The required strength of the beam is 80 kN-m of bending moment. The analysis found that the calculated flexural capacity of 82.58 kN-m exceeds the required strength, so the beam design is safe.

Uploaded by

Yan Yan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FLEXURAL ANALYSIS OF SINGLY REINFORCED RECTANGULAR BEAM

based from ACI 318-14

Programmed by: ENGR. RYAN M. LAYUG | [email protected]

A. INPUT DATA

Beam Section:

250mm x 400mm, 5 - 20mm ϕ

Beam Dimension: Strength Parameters:

b ≔ 250 mm fc' ≔ 17.7 MPa


h ≔ 400 mm fy ≔ 230 MPa

Reinforcement Paremeters: Required Strength:

db ≔ 20 mm Mu ≔ 80 kN-m
ds ≔ 10 mm
concrete_cover ≔ 50 mm
layer_clear_spacing ≔ 50 mm

⎡ Nlayer1 ⎤ ⎡ 3 ⎤
⎢ ⎥≔⎢ ⎥
⎣ Nlayer2 ⎦ ⎣ 2 ⎦

B. ANALYSIS

C. RESULT D. FIGURE

Steel_Ratio_Percentage = 2.08 % 450

Ductility_Percentage = 38.82 %
400
Ductility = “Ductile”

350
ϕ ⋅ Mn = 82.58 kN-m
Mu = 80 kN-m 300

Remark = “Safe”
250

rebar_clear_spacing = 35 mm
200
Rebar_clear_spacing = “OK”
150

100

50

0
0 50 100 150 200 250 300

Project Name: Owner:


Location: Civil Engineer / Designer: Page 1 of 1

You might also like