Scribd
Upload
11 views

Assignment

The document outlines calculations for various types of footings including rectangular combined footing, trapezoidal footing, mat foundation, and square footing based on given loads and soil conditions. It specifies requirements for dimensions, thickness, and reinforcement for each footing type. Additionally, it provides parameters such as soil bearing capacity and material grades necessary for the design process.

Uploaded by

Yedenekachew Nigussie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views

Assignment

The document outlines calculations for various types of footings including rectangular combined footing, trapezoidal footing, mat foundation, and square footing based on given loads and soil conditions. It specifies requirements for dimensions, thickness, and reinforcement for each footing type. Additionally, it provides parameters such as soil bearing capacity and material grades necessary for the design process.

Uploaded by

Yedenekachew Nigussie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

1. Refer to Figure 1.1.

Given
Material: qall(net) =140 kN/m2 C-25 S-300 ϕb = 12mm
Column: Both Columns C1 and C2: 30cm x 30cm;
Based on the location of the property line, it is required that L2 be 1.5m. Determine:
a. the size (B x L) of the rectangular combined footing.
b. The thickness of the footing.
c. The reinforcement of the footing.

Q1+Q2
Q1 = 400KN Q2=500KN
Xc =3.5
L2
L1

B qall
Property line

Figure 1.1 Rectangular combined footing

2. For the data given below determine the size of trapezoidal footing.

Q1 = 1000 kN Q2 = 400 kN L3 = 3 m qallnet = 120 kN/m2

Based on the space available for construction, it is required that L2 = 1.2 m andL1 = 1m.
Determine B1 and B2.

3. A 10m x 36m mat foundation is placed at 2.0 m depth in sand where the average value of N60
is 23. Determine the allowable net pressure that would limit the settlement to75mm.
4. For the axial column load (P) = 1000KN and moment of 100KN-m determine:
a. The size of rectangular footing
b. The thickness of the footing
c. The reinforcement of the footing

Soil bearing capacity of 200kPa, Grade of bare (fy)=300, concrete grade, C20 The
column size is 30x50cm, L = 1.2B

5. Design the square footing for the axial column load of 800KN and the following given data.
Soil bearing capacity of 180kPa, Grade of bare (fy)=300, concrete grade C20, The column
size is 40x40cm,

You might also like